Sanyo CH3632 Service procedures Check before and after Troubleshooting, Check power supply

4. Service procedures

(1)Check before and after Troubleshooting

Many problems may happen because of wiring or power supply problems, so you should check these areas first. Problems here can cause false results in some of the other tests, and so should be corrected first.

1. Check power supply wiring

❑Check the power supply wires are correctly connected between terminal No. 1 & 2 on the 5P terminal plates in the indoor unit and the outdoor unit.

2. Check inter-unit wiring

❑Check that inter-unit control wiring (DC low voltage) is correctly connected between the indoor unit and outdoor unit.

Power Supply: 60 Hz, single-phase, 230/208 V

Section

1

Disconnect SW		Inter unit
(Field supply)		power line
		230/208 V
1		B		1
2				2
G	Ground			G
U1	C		U1	L1
U2			U2	L2
	Inter unit
Indoor control line				G
Unit	DC 5 V		Outdoor

Unit

Power supply single phase

230/208 V

L1

AL2

Ground

1103_M_I

Fig. 19

2

3

3. Check power supply

❑Check that voltage is within the specified range (±10% of the rating).

❑Check that power is being supplied.

If the following troubleshooting must be done with power being supplied, be careful not to touch any uninsulated live part that can cause ELECTRIC SHOCK.

4. Check the lead wires and connectors in indoor and outdoor units.

❑Check that the sheath of lead wires is not damaged.

❑Check that the lead wires are firmly connected at the terminal plate.

❑Check that the wiring is correct.

4

SM830076

– 55 –