Sanyo CH2432, XHS3632, XHS2432, CH3632 service manual Change the shift temperature in heating mode

4. Service procedures

Section

1

2

(H)Change the shift temperature in heating mode

❏If the indoor unit is installed at high location (ex. ceiling level), the thermostat tends to turn off at heating mode because of the hot air temperature around ceiling level. In order to solve the problem, the shift temp. (valid while heating only) is set when shipped from factory.

❏If the shift temp. is not enough (ex. the indoor unit is installed at position higher than 3 m), the shift temp. can be set with remote controller from +1 to +10 deg (°C) <from +2 to 20 deg (°F)>. manually as follows:

aPress the TEST / CHK button for more than 4 seconds.

AIR FLOW
UNIT	UNIT No.	MODE
FLAP	R.C. No.
	CODE No.	SET TEMP.
TIMER SET

FAN SPEED

SETTING

SET DATA

SET CL

ON •

OFF •

TEST / CHK

3

4

0365_M_I

bIn case of group control, if you want to change all units in group control collectively, proceed next step remaining ALL displayed.

If you want to change a unit individually, select the indoor unit address (UNIT No.) with UNIT button.

cSelect the CODE No. 06 with , (SET TEMP) button.

dChoose the shift temp with , ( ) button.

			EX:
			UNIT No. 1–6
AIR FLOW			CODE No. 06
UNIT	UNIT No.	MODE	Shift temp. +5 deg (°C)
FLAP	R.C. No.	SET TEMP.	<+10 deg (°F)>
	CODE No.
TIMER SET
	SET TEMP.	FAN SPEED
	SETTING
	SET DATA
SET CL
	ON •
	OFF •
		TEST / CHK

0366_M_I

ePress the SET button.

CODE No. 06, SET DATA and SETTING change from flashing to ON state.

fIf you made a mistake, press the CL button.

gFinally, press the TEST / CHK button.

SM830076

– 82 –