closer than approximately one foot from the engine's lower unit. This will prevent cavitation (bubble) interference with propeller operation.
5.If possible, route the transducer cable away from other wiring on the boat. Electrical noise from engine wiring, bilge pumps and aerators can be displayed on the sonar's screen. Use caution when routing the trans- ducer cable around these wires.
CAUTION: Clamp the trans- |
|
ducer cable to transom near |
|
the transducer. This will help |
|
prevent the transducer from |
|
entering the boat if it is |
|
knocked off at high speed. | Good location |
Good | Poor location |
| |
location | Good location |
Poor angle |
|
Good and poor transducer locations.
How low should you go?
For most situations, you should install your Skimmer transducer so that its centerline is level with the bottom of the boat hull. This will usually give you the best combination of smooth water flow and protec- tion from bangs and bumps.
10