Eagle Electronics 500C To adjust sensitivity in auto mode, To adjust sensitivity in manual mode

can adjust sensitivity up to 100 percent but the unit will limit your minimum setting. In auto, the unit will continue to make small ad- justments, allowing for the setting you selected.

In manual mode, you have complete control over sensitivity, with the ability to set it anywhere from zero to 100 percent. Once you select a level in manual, the unit will continue to use that exact sensitivity set- ting until you change it or revert to auto mode.

To adjust sensitivity in auto mode:

1.Press MENUENT.

2.The Sensitivity Control Bar appears. Press ↓ to decrease sensitivity; press ↑ to increase sensitivity. When it's set at the desired level, press EXIT. (When you reach the maximum or minimum limit, a tone sounds.)

At left, Sonar Menu with Sensitivity command selected. At right, the

Sensitivity Control Bar.

To adjust sensitivity in manual mode:

1. First, turn off Auto Sensitivity: from the Sonar Page, press MENU↓

to AUTO SENSITIVITYENT.

2.Press ↑ to SENSITIVITYENT and the Sensitivity Control Bar appears. Press ↓ or ↑ to pick a different sensitivity setting. When it's set at the desired level, press EXIT.

To turn Auto Sensitivity back on:

From the Sonar Page, press MENU↓ to AUTO SENSITIVITYENTEXIT.

NOTE:

To return to the original factory setting for Auto Sensitivity, see the entry in this section on Reset Options. If sensitivity is in manual

76