www..reelschel matic..com
Insert the HDR 600 from the front of the panel. Install the “U” bracket and wing nut from the rear of the panel ensuring that the face of the HDR 600 is rotated upright.
If the panel into which you are mounting the unit is greater than ¼” thick, the “U” bracket may appear too long. You may modify the “U” bracket by using pliers to break the legs of the “U” bracket at the score lines.
Shorten the bracket gradually to avoid making it too short. Tighten the wing nut to secure the installation.
Once the unit is secured to the dash, the buzzer can be secured either to the metal bracket or a nearby wire bundle using the cable ties included.
Plug the transducer cable to the transducer connector. Notice the connector is keyed to prevent reverse installation, so be careful not to force the plug into the connector. Next, proceed with making the electrical connections.
If your boat has an electrical system, there is probably fuse panel in the console area, which can be used to attach the HDR 600 power cable. If a fuse terminal is available, use