www..reelschel matic..com
Inside the boat there is often a channel or conduit used for other wiring, which can be used to route the transducer cable forward. The transducer cable should not be cut or shortened, and care should be used not to damage the cable insulation. Also, be sure to route the cable as far as practical from the antenna cable of VHF radios or tachometer cables to reduce the possibility of interference.
If the cable is too short for your application, extension cables are available at a reasonable cost which can extend the transducer cable up to a total of 50 feet. Call Humminbird Customer Support for more information.
INSTALLATION
INSTALLING THE HDR 600
Before installing the HDR 600, gather the parts you need: HDR 600, “U” Bracket, mounting hardware, cable ties and transducer cable.
Next, consider where to mount the HDR 600. Try different positions on the console or deck of the boat. Remember that the cables for the transducer and power must reach the mounting location. Extension cables are available.
The mounting surface should be visible to the boat operator and adequately supported to protect the HDR 600 from excess wave shock and vibration. Allow at least 2” clearance at the back, sides, and top of the unit for connection, air flow, and ease of removal and installation.
Mark the desired location and drill a pilot hole.
Drill a 2 1/8” diameter hole using a hole saw and hand drill. This is a standard hole saw readily available for rental or purchase. Or, any marine service shop can handle this task.