•Remove bottom door support bracket and screw opposite the door hinge using a 3/8" socket wrench (see Fig. 3).
DOOR
SUPPORT
BRACKET 
Figure 3
FRONT FIXED CASTER INSTALLATION
•Put two (2) carriage bolts through the rear
•Hold the caster in position, insert the carriage bolt heads into slots A & B near the front of the caster rail and slide the caster back.
•Insert the two (2) front carriage bolts thru the top side of the caster rail and then thru the front holes on the caster. Attach locking nuts to each.
•Tighten all locking nuts securely using a 1/2 inch wrench (see Fig. 4).
•Repeat the same procedure for the other fixed caster.
| BRAKE |
|
FRONT OF | LOCKING NUTS | |
CASTER RAIL |
|
|
| FIXED CASTER |
|
CARRIAGE | CARRIAGE BOLTS | Figure 4 |
| ||
BOLTS
SLOTS A&B
REAR SWIVEL CASTER INSTALLATION
•Place a washer on one of the four long bolts and then feed the bolt through the hole in one of the swivel casters (see Fig. 6).
•Next, insert that same caster bolt through the hole on the metal spacer plate and then thru the rear hole of the caster rail (see Fig. 7).
•Thread the caster bolt into the hole in the
•Tighten both top and bottom bolts securely using a 1/2 inch fixed or socket wrench.
•Repeat the same procedure on the left hand side. After installation, carefully tip the unit up with the help of an assistant.
Bolt
SPACER
PLATE
Washer 
Swivel
Caster
Figure 6 | Figure 7 |
CASTER RAIL INSTALLATION
•Place a washer onto one of the four long bolts and slide bolt through the hole located just behind the fixed caster at the front of caster rail.
•Align the caster rail assembly with the right hand side of the unit. Make sure the fixed caster is positioned toward the front of the unit.
•Align the bolt with the threaded hole in the front right foot pad of the unit. Thread the bolt into the hole until finger tight (see Fig. 5).
WASHER 
BOLT 
WASHER
Figure 5
BOLT
4
