| Pan head screws |
| |
| M4x8 4 pcs. | to one of the screws | |
| Cable clamping plate | ||
Shield cover | of the cable clamping plate | ||
| |||
Gasket |
| ||
Pan head screws | |||
| |||
M4x8 7 pcs. |
| to J801 on | |
Shield cover |
|
| |
Pan head screws |
| ||
M4x8 7 pcs. |
| to J802 on | |
|
| ||
|
| to J611 on |
Antenna unit, inside view | Signal cable, antenna unit side |
7.Pass the cable through the hole at the bottom of the radome base.
8.Secure the cable with the cable clamping plate and gasket. Ground the shield and vinyl wire by one of the screws of the cable clamping plate.
9.Connect the wire to the RF unit.
10.Attach the EMC core supplied as shown below.
J801 | J802 |
Cable entry
J611
RF unit
| J801 | J802 | J805 | MD9208 |
|
| |||
|
| J804 |
| J806 |
|
|
|
| |
|
|
| J803 |
|
Cable |
|
|
|
|
entrance |
|
|
|
|
Cable |
|
| Motor |
|
clamping plate |
|
|
| |
|
|
|
| |
EMC core |
|
|
|
|
E04SS251512 |
|
|
| |
(Above cable | J1 |
|
|
|
clamping |
|
|
| |
plate) |
|
|
|
|
|
|
| J613 | |
|
| J611 | IF9214 | |
|
|
| ||
How to attach EMC core
11.Fix the shield cover. Do not pinch the cable.
12.Attach the radome cover, aligning triangle mark on radome cover with that on radome base.
Radome cover
Radome base
How to position the radome cover
13.Loosely fasten the radome fixing bolts. You will tighten them after confirming magnetron heater voltage.