Harbor Freight Tools 69662 manual Tool Set Up, Operating Instructions, Setup No rati

Page 8

y fet Sa

Operating Instructions

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

Tool Set Up

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:

Make sure that all Power Switches/Triggers is in the off‑position and unplug the tool from its electrical outlet before performing any procedure in this section.

Operating Instructions

Setup

no rati

1.Plug 120 V~ device(s) into the receptacles. Switch all devices off. The devices must not use more than the rated wattage during continuous operation, otherwise they may overload the Inverter.

2.Turn the inverter’s Switch on.

NOTE: Some rechargeable tools/appliances may damage the Inverter or the device(s). When first using a rechargeable device, check the Inverter’s temperature for the first ten minutes. If it becomes abnormally hot, do not use the device with the Inverter.

3.Turn the tool or appliance(s) on, one at a time. If the alarm sounds, turn off the device(s). Unplug the device(s) from the Inverter. Check the wattage of the devices, if there were multiple devices plugged in, discontinue use of one or more. If a single device set the alarm off, it is not appropriate for use with the Inverter.

4.If the inverter is powered by a vehicle’s starting battery, be careful not to discharge the battery to the point that it will no longer start the engine. If needed, operate the engine periodically to maintain the batteries charge. Do not operate a vehicle’s engine in an enclosed space.

5.Inverter will consume some power while on, even without loads attached. Turn inverter off after use.

Ope

Typical Appliance Power Consumption

ec

Maintenan

Product

Wattage

Laptop

50

Stereo

200

Mixer

200

Table Fan

200

TV-VCR

250

Computer

250

Small Refrigerator

350

Jigsaw

350

Belt Sander

350

3/8" Drill

350

Blender

350

Laser Printer

400

Food Processor

400

Product

Wattage

Reciprocating Saw

600

AC (5,000 BTU)

700

Vacuum

750

Chest Freezer

800

Coffee Maker

850

Iron

1050

Mini Microwave

1200

Hair Dryer

1200

10" Saw

1350

Note: This chart is intended as a general guideline only, actual appliance wattage requirements will vary. Some appliances listed above may require a pure sine wave inverter instead for proper operation.

Page 8

For technical questions, please call 1-800-444-3353.

Item 69662

Image 8
Contents Page Installation Precautions Table of ContentsGeneral Precautions Battery Precautions Operation PrecautionsSafety Setup MaintenanceService Precautions SymbologyDo not open housing. Contains no user-serviceable parts Fet SaSetup Operation Maintenance SpecificationsOutput Waveform Modified Sine WaveFor technical questions, please call Setup No rati Ope MaintenanInstallation Functions Operation Maintenance12 V / 400 Ah Battery Bank Example Tool Set Up Typical Appliance Power ConsumptionSetup No rati Operating InstructionsCleaning, Maintenance, and Lubrication SafetyMaintenance and Servicing Do not open housingProblem Possible Causes Probable Solutions TroubleshootingFet Sa Setup No rati Ope Maintenan Parts List and Diagram Part DescriptionQty Part Description QtyLimited 90 Day Warranty Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800