Vector VEC024 owner manual Common Problems, Buzzing Sound in Audio Systems

Page 12

recharged. The user should stop operation of the electronic device at this time since the inverter will shut down automatically shortly thereafter, when the battery voltage drops to 10 volts. Start your engine to recharge the battery.

If the low voltage alarm sounds when the battery is fully charged, follow the steps for solving lack of output power in the Troubleshooting Guide. The alarm will sound when the inverter is overloaded, in thermal shutdown, or if there is an excessive voltage drop between the battery and inverter.

NOTE: It is normal for the alarm to sound while the unit is being connected to, or disconnected from, the power source. This is not indicative of a problem.

7.COMMON PROBLEMS

“BUZZING” SOUND IN AUDIO SYSTEMS:

Some inexpensive stereo systems and “boom boxes” emit a buzzing sound from their speakers when operated from the MAXX 400 SST power inverter. This occurs because the power supply in the electronic device does not adequately filter the modified sine wave produced by the inverter. The only solution to this problem is to use a higher quality sound system that incorporates a higher quality power amplified supply.

TELEVISION INTERFERENCE:

The Vector MAXX 400 SST is shielded to minimize interference with TV signals. However, in some instances, some interference may still be visible, particularly with weak TV signals. Try the following corrective measures:

Position the inverter as far as possible from the television, the antenna and the antenna cables. Use an extension cable, if necessary.

Adjust the orientation of the inverter, the antenna cables and the TV power cord to minimize interference.

Make sure that the antenna feeding the television provides an adequate (“snow free”) signal and that high quality, shielded antenna cable is used.

12

12

Image 12
Contents Power Inverter Important Safety Instructions Read All Instructions Before Using This Power InverterContents CONTROLS, Indicators and Connectors IntroductionHOW Your Vector Inverter Works Principle of OperationInstallation Power Source RequirementsMaxx SST 400 Watt Output Waveform Connection to Power Source Connecting to Power Source Using 12 volt DC PlugDirect Hardwiring to Power Source Placement of the Inverter Connection to LoadBattery Operating Time Operating TipsRated Versus Actual Current Draw of Equipment Protective Features of the Inverter Common Problems Buzzing Sound in Audio SystemsTroubleshooting Guide Inverter Power Switch Turned onFuse Replacement SpecificationsWarranty Warranty Registration