Windsor Priza manual Putting into operation for the first time, b, Putting into practical use

Using the cleaner in any other way is considered to be contrary to its intended purpose. The manufacturer will not be liable for any damages that occur as a result of improper usage. In such cases liability rests solely with the user.

Putting into operation for the first time

„Affix the suction tube to the floor nozzle and secure the connection by tightening the union nut in an anticlockwise direction.

Important note: Make sure that the spray tube lying inside the tube is properly connected, otherwise this will lead to a malfunctioning of the unit.

„If required, push the handle on to the suction tube and screw it tight at the required position using the enclosed allen key.

„Affix the elbow to the suction tube and secure the connection by tightening the union nut in an anticlockwise direction.

„Put the suction hose of the spray- suction hose on to the connector on the unit (Fig. 1a). Press the coupling of the spray hose on to the connector. Make sure they engage properly (Fig. 1b).

„Place the spray-suction hose firmly on the grip section (Fig. 2a) and place the coupling of the spray hose on the connector of the grip section. Make sure they engage properly

(Fig. 2b).

„Put on the suction tube and floor nozzle and make the connection secure by turning the union nut by hand in an anti-clockwise direction.

„The hand nozzle for cleaning upholstery (optional accessory) is placed directly on the spray-suction hose.

„If required, the step nozzle (special accessory) or the metal floor nozzle can be used.

Putting into practical use

„Mix cleaning agent (RM) and clean water thoroughly in a clean container in accordance with the instructions (Fig. 3).

„Fill fresh-water tank up to the “Max.” line, but not above this (Fig 4).

Note: Warm water increases cleaning efficiency (max. 122 °F/+50 °C).

„Place dirty-water container in the housing and put the lid on.

„Put power plug in the socket.

„Switch on unit with the “Suction” and “Spray” buttons (Fig. 5).

„To spray - press lever on grip section and keep it pressed. By doing so the cleaning solution is sprayed on and in the same process is vacuumed up (Fig. 6).

„Go over the surface to be cleaned in overlapping strips with the relevant nozzle, put on the nozzle and work backwards

(Fig. 6).

„When the dirty-water reservoir is full or the fresh-water tank is empty, it is essential to turn the unit off with the “Suction” and “Spray” buttons.

„Remove cover, take out dirty-water reservoir and empty it (Figs 7, 8).

„Repeat working steps if necessary.

Cleaning carpets and upholstery

„For cleaning carpets, apply the 9.1 in (230 mm) floor nozzle.

„For cleaning upholstery, stair carpets, wall hangings or the inside of the car, apply the 4.3 in (110 mm) hand nozzle (optional accessory).

„When cleaning upholstery, the amount of cleaning solution must be reduced for delicate fabrics and the surface wetted at a distance of approx. 7.9 in (200 mm).

English 5