Mercury Marine 899846001 manual Manufacturers Plate, Wind Force and Wave Height

Page 22

GENERAL INFORMATION

Manufacturer's Plate

The manufacturer's plate is located on the inside of the boat transom.

			c
b			d
b
a			e
a
			14598
i	h	g	f
	h		f

a - Boat design category ‑ see following table b - Certified Europe Insignia

c - Model number

d - Maximum load capacity ‑ people + outboard + fuel tank and equipment

e - Maximum outboard weight

f - Pressure of the air chambers g - Maximum outboard power h - Maximum number of people

i - ISO 6185 part ‑ see following table

Boat design category ‑ The following table shows the navigation use that the boat was designed and constructed for.

Boat Design Categories

A

B

Navigation

Ocean

Offshore

Wind Force and Wave Height

Designed for extended voyages where conditions may exceed wind force 8 (Beaufort scale) and wave heights of 4 m (13 ft.) and above.

Designed for offshore voyages where conditions may experience wind force 8 (Beaufort scale) and wave heights up to 4 m (13 ft.).

18

Image 22

Contents Warranty Message Heavy Duty 380, 430HIN Table of Contents Cleaning Procedure Deflating Folding Instructions Transfer of Warranty Warranty InformationWarranty Registration United States and Canada What is Covered Duration of Coverage What Mercury will doHOW to Obtain Warranty Coverage What is not CoveredDisclaimers and Limitations Boaters Responsibilities General InformationBefore Operating Your Boat Lanyard Stop Switch General Information Protecting People In The Water While YOU are CruisingWave And Wake Jumping While Boat is StationaryImpact With Underwater Hazards Exhaust Emissions Be Alert to Carbon Monoxide PoisoningGood Ventilation Poor VentilationSafe Boating Suggestions While Boat is MovingGeneral Information Specifications Models with PVC FabricModels with Hypalon Fabric 530Manufacturers Plate Wind Force and Wave HeightPowered Boat Rating Back View Boat ComponentsComponent Location ‑ PVC Models Front ViewTransom View Side ViewComponent Location ‑ Hypalon Models Model 380 shown Transporting Trailering BoatFloorboard Installation Models with Wood Floors OperationSlide the rear floorboard No.5 under the transom retainer. b Side joiners Floorboard Installation Models with Aluminium Floors Six board model Slide the rear floorboard under the transom retainers. b 24122 Inflating Closed position Valve capOverpressure Security Valve ‑ Hypalon Models Outboard Power Pre‑Operating Check ListLoading Slide Drain Valve Operation Drain Valve OperationPlug Drain Valve Operation Air Chamber Deflates Accidently TowingBeaching Cleaning Procedure MaintenanceDeflating Folding Instructions 23508 Repairs Air Chamber Repair ‑ Hypalon FabricONE Part Glue Emergency Repairs only Air Chamber Repair ‑ PVC FabricTWO Part Adhesive Repairs Repairs Storage Storage PreparationParts And Accessories Inquiries Owners Service AssistanceService Assistance Service Away From Home