Baja Marine 25 manual Starting the Engine

Page 76

Section 8 • Required Inspection, Service, &

Maintenance

Quick Reference Checklist (contd)

B.Preparing to Depart and After Launching

General

 

 

1.

Bilge/Engine Compartment

“Sniff” the bilge/engine compartment for

fuel odor.

 

 

Run the bilge blowers for at least four (4)

minutes.

2.

Shore Power Cable

Disconnected from dockside power inlet

 

3.

Lines, Fenders and Anchor

Ready for use

 

4.

Passengers/Crew

Instructed in duties for getting underway and fitted for a

 

 

correct size PFD

 

Engine

 

 

1.

Battery Switches

In the ON position

 

2.

Fuel Valves (Diesel Only)

Open

 

3.

Engine Alarm

Test. Should sound after a few seconds

 

4.

Gear Shift & Throttle Controls

In NEUTRAL and IDLE positions

 

Starting the Engine*

 

 

1.

Gearshift & Throttle Controls

Shift in NEUTRAL (Refer to your Engine Owner’s

 

 

Manual for startup procedures for your specific

 

 

engine)

 

2.

Ignition

Turn ignition keys on the helm clockwise until engine

 

 

starts, then release.

 

IMPORTANT: Do not continue to operate starter for more than 10 seconds without pausing to allow starter motor to cool off for 2 minutes. This also will allow the battery to recover between starting attempts.*

!WARNING

Do not run the engine or generator in an enclosed area, such as a closed boat house, as there is the possibility of buildup and inhaling of carbon monoxide.

*If engine fails to start, refer to the Engine Owner’s Manual for further troubleshooting procedures

25 Outlaw®

8.9

Image 76
Contents Baja Marine OutlawFor information call 1-865-971-6270 or fax Welcome This page intentionally left blank Introduction HIN Number Hull Identification Number HINAbout Your Express Limited Warranty Iii Ignition Protection Breakers and/or Fuses Speed changes you. TM Safety Safety LabelsFire Extinguishing System Legally Mandated Minimum Required EquipmentCarbon Monoxide Carbon Monoxide Monitor Lifesaving Equipment Additional Recommended Equipment for Safe Operation Impaired OperationLoad Capacity Power CapacityPropellers Stability Maintain ControlWeather Chart Your CourseGeneral Considerations Swimming Water SportsSkiing Emergency Situations GeneralMedical Emergency Water RescueFire Flooding, Swamping and CapsizingSafety Hotlines Collisions and LeakingGrounding Propulsion, Control or Steering FailureEnvironmental Considerations International RequirementsFuel and Oil Spillage Wake/Wash Waste DisposalExcessive Noise Nautical Terms Key to Symbols on Controls & Prints Only w/ fire port Optional with water tank This Page Intentionally Left Blank General Boat Arrangement Docking /Lifting /Trailering Passenger Locations2 Hull Basic Boat Dimensions and Clearances Metric Propulsion SystemGeneral Deck Layout General Deck Layout FIGDescription of Major Controls Power Trim Unit and GaugeGear Shift and Throttle Control Trailer Switch Trim TabsIgnition Shutdown Switch Engine Alarm SystemImportant Gauges Tachometer and Hour MeterOil Pressure, Water Temperature, Voltmeter and Fuel Gauges Navigation and Anchor LightsUsing Your Boat Pre-Launch, Launch and Post- Launch ChecklistTrailer Launching and Loading Fueling the BoatBoarding Personal Flotation DevicesPassenger Instruction and Location Starting the EngineShifting to Drive the Boat Stopping the EngineSteering Systems Hydraulic SteeringPower Steering Power Steering SystemThis page intentionally left blank Bilge & Underwater Gear BilgeFuel & Oil Spillage Drain PlugMaintenance and Service Engines and Stern DriveBilge Blowers Vibration and CausesPropeller Removal and Installation Impact to Stern DriveGear case Fuel System Fuel SystemAnti-Siphon Valve Inboard/Outboard Engine Only Before and During Fueling Checklist Fueling PrecautionsStatic Electricity and the Fuel System After Fueling Checklist This page intentionally left blank Electrical Systems Electrical SystemsDirect Current DC BatteriesBreakers and/or Fuses Electrolytic Corrosion & Zinc AnodesFuse Panel Marine Electronic Cathodic Anti-corrosion System Mercathode Ignition Switch Drive Pump Switch Panel Wire Information FIG Switch Panel Wire Information FIG DC Wire Information FIG This Page Intentionally Left Blank Options & Accessories Options & Accessories LocationsFire Extinguisher Port Automatic Fire Extinguisher System OptionCanvas Canvas Care and Maintenance Swim Platform w/ Ladder OptionalDepth Finder Optional HornStereo System Head SystemsPortable Self-Contained Head Requirements for OperatorsExhaust Systems Portable Head with Pump-OutThis page intentionally left blank Summary Guide for Inspection, Service and Maintenance Required Inspection, Service MaintenanceInterval Summary Guide For Inspection, Service and Maintenance IntervalUseful Service Information Inspection, Service and Maintenance Protocol Bilge AreaWinterization Checklist for Boats Stored on Land BatteryiesTopside and Supplies Boat StorageFitting Out After Storage Fuel SystemsFuel System MiscellaneousPower Steering System Maintenance Security ConsiderationsBoarding the Boat General Quick Reference ChecklistBoat Systems Starting the Engine Quick Reference Checklist cont’d Departing General Returning to Port GeneralSecuring the Boat Quick Reference Checklist cont’dIf the Engine Does Not Start After Market Equipment Checklist Maintenance Log Maintenance Log Cont’d Paint Cleaning Agents & Other Substances Care & RefinishingStains & Scratches Fiberglass & GelcoatPermanently Moored or Docked Boats Topside AreasAcrylic Plastic Sheeting Plastic Glass Canvas and Clear VinylExterior Upholstery Fabric Interior Upholstery FabricThis Page Intentionally Left Blank Index Index Outlaw