Baja Marine 35 manual Shifting to Drive the Boat, Stopping the Engine

Section 3 • Using Your Boat

it is recommended that the bilge blower run all the time the engine is running.

6.Place drive unit in full DOWN/IN position.

7.Put shift control lever into neutral; then for a:

COLD ENGINE - Move throttle lever forward to full open throttle, then return to about 1/4 throttle. In cold weather, it may be necessary to pump lever several times before engine will start.

WARM ENGINE - Move throttle lever about 1/4 open throttle position. Do not pump lever.

FLOODED ENGINE - Move throttle lever to full open position. DO NOT pump lever. When the engine starts, move throttle lever back rapidly to decrease engine speed to between 1000 and 1500 RPM.

8.Shifting to Drive the Boat

Bring throttle lever all the way back. Once done, the drive is ready to shift.

Move shift lever either forward or reverse. Then move throttle lever forward, the drive unit will engage and boat will start to move slowly in either forward or reverse. Once clear of the dock, mooring, people and/or the no-wake zone and the boat has been shifted into forward gear, move throttle lever forward to desired engine speed.

!caution

Cockpit can fill with water if boat is moving forward, when it is put into reverse.

Before shifting into reverse, shift to neutral, wait for the boat to stop moving forward, then shift into reverse.

8. TO START ENGINE:

Turn ignition keys clockwise,

as you would an automobile

(Fig. 3.5.1)

9.Stopping the Engine

	(Fig. 3.5.1).
9.	After engine starts, reduce
	speed to between 1000 and
	1500 RPM and check oil
	pressure.
10.	If oil pressure is correct, let
	engine warm up to normal
	temperature range as specified
	in the engine manual, before

(Fig. 3.5.2)

1.Move throttle levers all the way back. Once done, move shift lever to neutral position, which is located in the center. (Fig. 3.5.4).

(fig. 3.5.4)

Throttle levers
in full throttle	Throttle
position	levers in idle
Shift levers	position
in forward
positon

Shift levers in reverse position

shifting into forward or reverse

gear (Fig. 3.5.2).

2. Turn ignition keys counter	(Fig. 3.5.5)
clockwise to turn off engine
(Fig. 3.5.5).

IF ENGINE TEMPERATURE	(Fig. 3.5.3)
GOES ABOVE NORMAL

RANGE. SHUT DOWN THE ENGINE IMMEDIATELY. GET TRAINED HELP TO FIND AND FIX THE PROBLEM (Fig. 3.5.3).

IF OIL PRESSURE GOES ABOVE OR BELOW OPERATING RANGE, SHUT ENGINE DOWN IMMEDIATELY. GET TRAINED HELP TO FIND AND FIX THE PROBLEM.

3. If you are leaving the boat	(fig. 3.5.6)
for more than two hours,

turn battery switches OFF (Fig. 3.5.6)

35 Outlaw® 3.5