3.Install seal (44) on retainer nut (11). Install retainer nut in pump adapter (8) (FIG. 14). Torque retainer nut to 54 to 56
4.Slide bottom cylinder cap (32) onto the cylinder (25) ensuring the tie rods (38) go through their respec- tive holes in the top cylinder cap (31).
NOTE: When attaching the bottom cylinder cap (32) onto the cylinder (25) be sure that the port (31b) in the top cylinder cap (31) and the port (32b) in the bottom cylinder cap (32) are in line with each other. Be sure
31
31b
13
25
13
32
32b
FIG. 15
Service
5.Install lock washers (37) and nuts (36) onto tie rods (38). Torque nuts to
36
37
38
FIG. 16
6.Install pump adapter (8) to motor housing (43). Install the lockwashers (27) and capscrews (15). Torque capscrews to
7.Reinstall fluid tube (45) and fittings (1). Torque fit- tings to 28 to 32
8.Install displacement pump, see Displacement Pump and Reciprocator Reassembly instructions, page 19.
312350K | 13 |