Graco 244637, 226013, 204490, 226018 important safety instructions Removing a Drum

Page 11

Operation

Removing a Drum

1.Relive pressure, see Pressure Relief Procedure, page 5.

2.Press in and hold the air-assist valve (47) until the inductor plate rises above the drum. Release the valve. (FIG. 9)

3.Open the snap-over valve (27) and raise the eleva- tor to full height. (FIG. 9)

NOTE: If you lose air pressure when reaching the drum chime, continue holding the air-assist valve and slowly pull out the snap-over valve until the chime is passed. Then, immediately close the snap-over valve to prevent raising the drum off the floor.

306556S

11

Image 11
Contents Topper Units Important Safety InstructionsContents Fire and Explosion Hazard Toxic Fluid Hazard Grounding the Pump InstallationPressure Relief Procedure GroundingMounting the Elevator Typical InstallationPositioning the Elevator Model Mounting the PumpModels 226013, 226018 All Models Installing the Hoses and ValvesInstallation Operation Installing a DrumRemoving a Drum Removing the Pump MaintenanceReinstalling the Pump Problem Cause Solution TroubleshootingRef Parts No. No Description Qty Model Elevator and Inductor Plate AssemblyRef No Part No Elevator Base Assembly PartsRef No Ref No Part No Inductor Plate Assembly 400 lb Drum sizeRef. No Restrictor Valve Assembly Mounting and Connecting Parts Ref No Part No Wishbone Support AssemblyDimensions Topper Units Metric Technical DataGraco Information Graco Standard Warranty