Chauvet DMX512 user manual COLORcon Setup, Menu  Settings  Range  No. of fixtures

COLORcon™ Setup

1.FIXTURE CONTROL PANEL SETUP

Activate ID addressing in each fixture by setting panel function {ID ON/OFF} to ON. {MENU}  {Settings)  {ID ON/OFF}  [ON]

Set ID addresses in each fixture by setting panel function {ID address} to incremental values. (I.e. 1,2,3,4,5,6,etc…)

{MENU}  {Settings}  {ID address}  [01 ~ 66] It is not necessary to set the DMX address.

2.CONTROLLER SETUP

When using the {Effect program} function, it is necessary to set the {Settings}  {Range} setting, which is the quantity of fixtures in series.

{MENU}  {Settings}  {Range}  [ (No. of fixtures) ]

Single Row Application

ID Address: 01 ID Address: 02 ID Address: 03 ID Address: 04 ID Address: 05 ID Address: 06

The figure above shows 6 fixtures connected in series with corresponding addresses. Each fixture has {ID ON} in the fixture’s settings. You must set the {Range} settings in the controller to [006] before accessing {Effect} programs.

SET UP DOWN EXIT

Repeat Row Block Application Block Application

ID Address: 01	ID Address: 02	ID Address: 03
ID Address: 01	ID Address: 02	ID Address: 03
ID Address: 01	ID Address: 02	ID Address: 03

ID Address: 01	ID Address: 02	ID Address: 03
ID Address: 04	ID Address: 05	ID Address: 06
ID Address: 07	ID Address: 08	ID Address: 09

The figure above shows 9 fixtures connected in series. Three rows comprised of 3 fixtures are addressed identically. Each fixture has {ID ON} in the fixture’s settings. You must set the {Range} settings in the controller to [003] before accessing {Effect} programs.

SET UP DOWN EXIT

The figure above shows 9 fixtures connected in series with corresponding addresses. Each fixture has {ID ON} in the fixture’s settings. You must set the {Range} settings in the controller to

[009]before accessing {Effect}

SET UP DOWN EXIT

programs.

COLORdash™ Par User Manual 14 9/4/2008 12:09 PM