Attwood 7450 Series, 7200 Series, 7400 Series, 7250 Series Connect Power to Switch, Maintenance

Page 2

Figure 4

Figure 5

 

 

In Line Fuse Holder

 

(pos)

(neg)

3-Position Switch (Off/On/On)

#10 Pan Head Screw

Battery

 

Black Wire to Ground (-)

1/8" (3mm)

Blue Wire (+)

Pilot Hole

Mast Light (Forward)

3/8" (10mm)

Gray Wire (+)

Wire Access Hole

Anchor Light (Aft)

Black

(To Negative)

Gray (pos-1)

Anchor Forward

(All Around)

Blue (pos-2)

Forward Running

CONNECT POWER TO SWITCH

Use ONLY the rated voltage. Higher voltage can damage light and void product warranty. All positive (+) wires must be protected by fuse (2-amp for 12-volt, 1-amp for 24-volt).

1.Use 3-position, double-pole OFF/ON/ON switch. (Figure 5)

2.From the anchor/masthead light, connect gray wire to one (+) switch terminal. This switch position should operate all-round anchor light (both lamps).

3.Connect blue wire to the remaining (+) terminal. This position should operate forward masthead running light only (one lamp forward) and all other navigation lights.

4.Test forward running and anchor lights for proper operation.

MAINTENANCE

1.To replace lens or lamps, remove top retaining screw and lens.

2.Replace lens with Attwood #912896.

3.Replace lamp(s) with Attwood #9230 (12-volt), #910409 (24-volt).

4.Reinstall lens and retaining screw.

5.To adjust tension on cam-lock adjustment handle: Use Phillips screwdriver to loosen screw in center of handle (Figure 2). Adjust tension so handle releases easily, and also holds light in position when locked.

ATTWOOD LIMITED WARRANTY

ATTWOOD CORPORATION, 1016 North Monroe, Lowell, Michigan 49331 (“Attwood”) warrants to the original consumer purchaser that Attwood brand products will be free from defects in materials and workmanship under normal use and service for one year from the date of original consumer purchases.

This limited warranty is not applicable if the product has been damaged by accident, improper installation, unreasonable or improper use, lack of proper maintenance, unauthorized repairs or modifications, normal wear and tear, or other causes not arising out of defects in materials or workmanship.

Attwood products are warranted for use on pleasure boats. Any other use—including but not limited to commercial, racing, or non-marine use—are not covered under this warranty. Attwood’s obligation under this warranty is limited to repair of the product at Attwood’s plant or replacement of the products at Attwood’s option without expense to the original consumer purchaser. Any expenses involved in the removal, reinstallation or transportation of the product are not covered by this warranty.

The product must be returned to Attwood’s plant at the address above, postage pre-paid, and insured with proof of original purchase including date. If Attwood is unable to replace the product and repair is not commercially practical or cannot be timely made, or if the original consumer purchaser is

willing to accept a refund in lieu of repair or replacement, Attwood may refund the purchase price, less an amount for depreciation. The acceptance by Attwood of any product returned or any refund provided by Attwood shall not be deemed an admission that the product is defective or in violation of any warranty. Products that are replaced or for which a refund is issued become the property of Attwood.

THIS WARRANTY IS ATTWOOD’S ONLY EXPRESSED WARRANTY OF THESE PRODUCTS. NO IMPLIED WARRANTY INCLUDING, WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE EXTENDED BEYOND THE WARRANTY PERIOD STATED ABOVE FOR EACH PRODUCT. ATTWOOD SHALL NOT BE LIABLE FOR ANY DAMAGES, FOR LOSS OF USE OF THIS PRODUCT, NOR FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES, COSTS, OR EXPENSES.

Some states do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations and exclusions may not apply to you. This warranty gives you specific legal rights, and you may have other rights which vary from state to state.

© 2004 Attwood Corporation

1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com

Image 2
Contents Installation Instructions FeaturesRequired for Installation Mounting LocationConnect Power to Switch Maintenance