6.Connect the power cord at the back of the instrument to a 12 V power supply which is active whenever the ignition switch is on.
The red lead should be connected to the positive terminal of the power supply via a 1 amp fuse or a 1 amp circuit breaker. The black lead should be connected to the negative terminal.
7.Obtain the power from a 12 V source as directly as possible. Avoid power circuits which share loads with ignition, alternators, radio transmitters, etc. Excessive electrical noise associated with such devices may prevent the instrument from operating properly.
8.Connect the RCA phono plug on the transducer cable to the instrument.
Instrument |
| |
Panel |
| |
Mounting Nut | ||
Hole | ||
| ||
| Mounting | |
| Bracket | |
Instrument |
| |
Sealing |
| |
Gasket |
|
Figure 2. Depth Sounder Installation
FACE PLATE
INSTRUMENT
PANEL WALL
MOUNTING
NUT
MOUNTING
BRACKET
DEPTH SOUNDER
BODY
Figure 3. Side View of Mounted Depth Sounder
10DS41 Owner’s Manual