Eagle Electronics 242 manual Transom

Page 16

the ground. The transducer's centerline should be in line with the bot- tom of the hull. Don't let the bracket extend below the hull!

Mark the center of each slot for the mounting screw pilot holes. You will drill one hole in the center of each slot.

Drill the holes. Use the #29 bit (for the #10 screws).

Transom

Transom

Position transducer mount on transom and mark mounting holes.

Side view shown at left and seen from above at right.

5.Attaching transducer to transom. Remove the transducer from the bracket and re-assemble it with the cable passing through the bracket over the bolt as shown in the following figures.

12

Image 16

Contents Cuda 242 Portable Copyright 2006 LEI-Eagle All rights reserved Table of Contents Troubleshooting Capabilities and Specifications Cuda 242 & Cuda Portable GeneralBack-up memory SonarSonar sounding Automatic rangingHow Sonar Works Installation PreparationsRecommended Tools and supplies Selecting a Transducer Location How low should you go? Shoot-Thru-Hull vs. Transom Mounting Transom Transducer Assembly and Mounting Align plastic ratchets in bracket Insert bolt and check transducer position on transom Transom Page Bottom Hull Flat-bottom hullDeep-vee hull Attach motor mounting bracket to transducer Transducer Orientation and Fish Arches Transducer angles and their effects on fish arches Shoot-Thru-Hull Preparation Testing Determines Best Location Second bottom True bottom Manual range setting Shoot-Thru-Hull Installation Epoxy transducer to hull Power Connections permanent mount only To unit Red wire with Amp fuse Black wire Volt battery Page 107.5 82.7 156 Page Portable Sonar Installation Installing the Batteries Mounting the Unit Page Tie Nylon Cord here Suction Portable Transducer Storage Page Operation Keyboard BasicsMenus MemoryUP & Down Arrows ↑ ↓ Display Full Chart Depth Range Zoom Zoom Range menu with the 40-80 foot zoom selected To adjust sensitivity in Manual Mode To adjust sensitivity in Auto ModeSensitivity Grayline Grayline control bar Chart Speed Chart Speed control bar Fish I.D. FishTrack Alarms Fish AlarmDepth Alarms Shallow AlarmDeep Alarm Battery Alarm Noise Reject and ASP Depth Display Temperature DisplayTo display Depth To display Temperature Voltage To display battery voltageUnits Backlight ContrastSimulator Set LanguageSoftware Information To select a languageReset Options Unit wont turn on Unit turns on only in simulator modeUnit freezes, locks up, or operates erratically Page No fish arches when the Fish I.D. feature is off NoisePage Eagle Electronics How to Obtain Service… Not toll-freeAccessory Ordering Information for all countries Visit our web site