![](/images/new-backgrounds/1255762/255762111x1.webp)
Troubleshooting
Problems | Possible Solution |
|
|
I pressed the power button | Make sure that you hold the power |
but the device doesn’t | button for two seconds to turn it off. |
switch off. | If the unit still doesn’t turn off, remove |
| the battery or the power source for five |
| seconds and install it again. |
The unit does not respond | The map position may be latched. Check |
when I try to move the | if the symbol is shown in the bottom |
cursor. | right corner of the map page. If so, press |
| and hold a direction key to unlatch the |
| device. |
What do I do to return to my | Check if the symbol is showing in the |
current position on the map | bottom right corner of the map page. |
page after I have moved the | Press the ESC button to return to your |
map? | current position |
| |
|
|
The ONIX 110 fails to locate | Make sure that you are not in simulation |
my current position. | mode. |
| Make sure you are in an area with |
| no obstruction such as trees or tall |
| buildings. |
| The ONIX 110 requires synchronization |
| with at least three satellites to identify |
| with your current location. Once the |
| position has been identified, it requires |
| at least one satellite to maintain status. |
| If available satellite signals are too low in |
| orbit or all in a line, it may not be able to |
| locate your current location |
|
|
56