To write some basic automation | Mackie X.200 instruction

21.In the Reverb panel, click the Src L drop-down box and select Channel Post Insert > Ch. 1 Post. This places the reverb in the post-insert loop on channel 1.

24.Select the WRITE button in the ASSIGN BUT- TON SETUP section of the console. Press the ASSIGN button on channel 1.

ASSIGN BUTTON

SETUP

REC

L - R

READ

WRITE

25.Start running time code by pressing the PLAY button in the Transport section of the console. You can see the time code in the upper-right corner of the screen.

Quick-Start Guide

22.Adjust the reverb parameters using the V-Pots at the bottom of the Effects Rack. You should see the Left Input and Output meters move as you talk or sing into the microphone.

Note: A more typical use for an effect in the Ef- fects Rack might be to route several channels to an Aux Send; for example, all the background vocals to Aux Send 1. Route Aux Send 1 to the input of the effect in the Effects Rack by selecting it in the Src (Source) drop-down box. The Aux 1 master fader (Masters Fader Bank) is used to control the amount of signal being sent to the effect. Return the effects signal to the signal path by selecting the effect's output for the input of an unused channel.

To write some basic automation:

23.In the AUTOMATION MODES section of the console, select FADER and MUTE. Turn off the BYPASS button.

AUTOMATION

MODES

TRIM

FADER

MUTE

PAN

ALL

BYPASS

EDIT	7	8	9	LOOP
START	7	8	9	START
START				START
END	4	5	6	STOP
SNAP	1	2	3	ON
SHOT	1	2	3	ON
SHOT
LOCATE	STORE	0	SET	ENTER
REWIND	FAST FWD	STOP	PLAY	RECORD

SCRUB

26.Move the channel 1 fader up and down a few times and press the mute button on channel 1.

27.Press the STOP button in the Transport section and press REWIND to return the time code to zero.

28.Press the PLAY button and the fader moves and mute will playback from automation.

29.You can open the Mix Editor (Windows > Mix Editor) to see the automation moves. Select Channels > Ch. 1 in the Show drop-down box at the top of the Mix Editor to see the recorded fader moves and mute action relative to the time code.

Quick-Start Guide