Mackie X.200 quick start More Connections, Power Switch

Page 7

15. Power Switch

This one is self-explanatory. When the POWER switch is turned ON, power is supplied to the Digital X Bus and it boots up. When turning off the Digital X Bus, you should select Shutdown from the File menu. At the end of the shutdown procedure, the touchscreens go blank, indicating that it is okay to turn off the power switch.

More Connections

There are even more connections available behind the removable panel on the back of the Digital X Bus, which we call the Motherboard Access Area. These are connections to the motherboard, and include four additional USB connections, and the PS/2-style mouse and keyboard connections.

To access the connectors:

16. Mouse

This 6-pin miniDIN connector is used to connect a PS/2-style mouse.

17. Keyboard

This 6-pin miniDIN connector is used to connect a PS/2-style keyboard.

18. USB

These are four additional USB ports for connect- ing more USB devices to the Digital X Bus. If you are connecting a USB CD-ROM drive, use one of these ports rather than the USB ports on the rear panel (13).

Quick-Start Guide

1.First, turn off the Digital X Bus (select File > Shutdown and then turn off the power switch).

2.Use a Phillips screwdriver to remove the eight screws securing the panel to the chassis.

MOUSE

KEYBOARD

USB PORTS

Quick-Start Guide

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents I C K STA R T G U I D E Table of Contents Introduction HOW to USE this ManualLine Card CardsMIC/LINE 4 Card MIC/LINE 8 CardMIX OUT Card Firewire CardDigital Card AES/EBU CardEthernet Other ConnectionsSync Card Serial 9 PINMore Connections Power SwitchAbout Fader Banks Turning on the Digital X BusGetting Sound Happening To patch an effect into the signal path To write some basic automation Hookup Diagrams Guide Start-Quick Surround Digital Audio United States and Canada
Top Page Image Contents