Volume, Tone & Circuit Board
To install the tone control, volume control, and power switch:
1.Remove hex nuts, flat washers, and interior tooth washers from the volume control, tone control, and power switch. Note the location of each of the nuts and washers. This will make it easier to reinstall the components.
2.Insert the volume and tone controls through flat washers and then into the sockets on the guitar body as shown in Figure 16.
Volume
Control
Tone
Control
Figure 16. Installing tone and volume controls.
3.Using a 10mm wrench, reinstall the nuts and washers removed in Step 1 and install the volume and tone control knobs.
4.Insert the grounding wire through the hole in the side of the circuit board mortise (Figure 17).
Note: It may help to use tweezers or pliers.
Hole
Grounding
Wire
Figure 17. Installing ground wire into side hole.
5.Thread the wire until it protrudes through the top of the guitar body. Place a piece of mask- ing tape over the wire to hold it temporarily.
6. | Insert the power switch, which is mounted to |
| the circuit board, through the guitar body, as |
| shown in Figure 18. |
| Power Switch |
| Figure 18. Installing power switch. |
7. | Reinstall the hex nut and interior tooth wash- |
| er removed earlier. |
Model H7582 Junior Electric Guitar Kit |