Samson S zone manual Zone Specifications

Page 23

	S zone Specifications
S zone Specifications
Input Impedance:
Mic	600Ω XLR balanced
Line	22K Ω
Max Input Level
Mic	-14 dBV balanced
Line	+24 dBV
Maximum Gain
Mic	60 dB
Line	26 dB
Output Level	+17 dBV max.
Output Impedance
Balanced	200 Ohms
Unbalanced	100 Ohms
Max. S/N ratio	96 dB
THD	<.02%
CMRR:	>52 dB (Mic)
Phantom power	+12 VDC
Tone Controls
LOW	+/- 15 dB at 100 Hz
HIGH	+/- 15 dB at 10 kHz
Connectors
Inputs	6 PIN Euroblock
Outputs	9 PIN Euroblock
Power Supply
Mains Voltages/selectable	USA/Canada	~120 V AC, 60 Hz
	U.K./Australia	~240 V AC, 50 Hz
	Europe	~230 V AC, 50 Hz
Fuse	100-120 V AC; 250 mA (slow-blow)
	200-240 V AC: 125 mA (slow-blow)
Power Consumption	5 Watts
Power inlet	Standard IEC receptacle with fuse
Dimensions	19 in. (w) x 7.5 (d) x 1.75 (h)
	482 mm (w) x 190 (d) x 44 (h)
Weight	5.1 lb. (2.31 kg)

21

Image 23

Contents L a s s S i g n a l P r o c e s s o r s Important Safety Instructions Table of Contents Introduction Zone Features Front Panel Layout Controls and FunctionsControls and Functions Designing an Installation Plan Using Active Speakers Using Passive SpeakersQuick Start Setting up the S zoneMic Trim Get Connected Connecting the S zoneConnecting the S zone Inputs Connecting the S zone Zone Outputs Connecting the S zone Zone InputsOperating the S zone Using the S zone Input SectionUsing the Zone Assignment switches Using the Volume ControlRouting a signal to the Internal Monitor Using the Monitor SectionUsing the headphone Using the Monitor Volume controlControlling the Zone Outputs Setting the Output levelSetting the Zone Output for Stereo or Mono Operation Setting the Zone Output EQ For Music Using the EqualizerSetting the Zone Output EQ For Voice Channel 2 Duck Enable Using the DuckerSetting The Duck Enable switches Channel 1 Duck EnableOperating the S zone Zone System Configurations Zone’s Four Room Set-up Zone Wiring Guide Zone Wiring GuideZone Specifications Zone Block Diagram Page Page