Samson S zone manual Controls and Functions

Page 7

Controls and Functions

Rear Panel Layout

AAC INPUT FUSE HOLDER – Connect the supplied 3- pin IEC power cable here.

BZONE 1 OUTPUT – This connector includes the Zone 1 Left and Right balanced output connections, along with the connections for the REMOTE volume con- trol.

CZONE 2 OUTPUT – This connector includes the Zone 2 Left and Right balanced output connections, along with the connections for the REMOTE volume control.

DZONE 3 OUTPUT – This connector includes the Zone 3 Left and Right balanced output connections, along with the connections for the REMOTE volume control.

EZONE 4 OUTPUT – This connector includes the Zone 4 Left and Right balanced output connections, along with the connections for the REMOTE volume control.

FLINE 3 AND 4 INPUT - This connector is used to hook up the LINE 3 and 4 Left and Right input con- nections.

GDUCK TRIM – This rotary control is used to adjust how much signal level is dropped when the micro- phone activates the DUCK circuit.

HMIC/LINE 2 – This connector includes the connec- tion for a stereo line level and mono microphone input for channel 2.

IMIC TRIM – The rotary control is used to adjust the input sensitivity of the microphone pre amplifier on channel 2.

JMIC/LINE 1 – This connector includes the con- nection for a stereo line level and mono micro- phone input for channel 1.

KMIC TRIM – The rotary control is used to adjust the input sensitivity of the microphone pre amplifier on channel 2.

LCH 1 MASTER switch – This switch is used to enable the ducking function on channels 2, 3 and 4.

MDUCK ENABLE– Channel 2 will act as a ducking master when this switch is pressed in and the volume of channels 3 and 4 will automatically be lowered when the there is a microphone signal on Channel 2.

NDUCK ENABLE – Channel 1 will act as a duck- ing master when this switch is pressed in and the volume of channels 3 and 4 will automati- cally be lowered when the there is a micro- phone signal on Channel 1.

5

Page 6 Page 8
Image 7
Page 6 Page 8
Contents L a s s S i g n a l P r o c e s s o r s Important Safety Instructions Table of Contents Introduction Zone Features Front Panel Layout Controls and FunctionsControls and Functions Designing an Installation Plan Using Active Speakers Using Passive SpeakersQuick Start Setting up the S zoneMic Trim Connecting the S zone Inputs Connecting the S zoneGet Connected Connecting the S zone Zone Outputs Connecting the S zone Zone InputsOperating the S zone Using the S zone Input SectionUsing the Zone Assignment switches Using the Volume ControlRouting a signal to the Internal Monitor Using the Monitor SectionUsing the headphone Using the Monitor Volume controlSetting the Zone Output for Stereo or Mono Operation Setting the Output levelControlling the Zone Outputs Setting the Zone Output EQ For Voice Using the EqualizerSetting the Zone Output EQ For Music Channel 2 Duck Enable Using the DuckerSetting The Duck Enable switches Channel 1 Duck EnableOperating the S zone Zone System Configurations Zone’s Four Room Set-up Zone Wiring Guide Zone Wiring GuideZone Specifications Zone Block Diagram Page Page
Top Page Image Contents