Guided Tour Rear Panel | Samson PL1602 guide

Guided Tour - Rear Panel

PL 1602 16 CHANNEL LINE MIXER

SAMSON TECHNOLOGIES CORP., NEW YORK, U.S.A.

POWER

S / N

MIC 1

INPUTS BALANCED 10KΩ

-30 to +4db TIP + RING - SLEEVE GND.

110

-10

OFF

+4 -40

TRIM

16R

15L

14R

13L

12R

11L

10R

AVIS:

RISQUE DE CHOC ELECTRIQUE

-10

NE PAS OUVRIR

DO NOT EXPOSE THIS EQUIPMENT

TO RAIN OR MOISTURE

-40

POWER

120V - 60 Hz 35W

TRIM

RATING

CAUTION

MAIN OUT

BUS

AUX

AUX SEND

INSERTS TIP RETURN RING SEND

MIC 3

~115V(0.3A)

RISK OF ELECTRIC SHOCK

BALANCED 600 +4db

INSERTS

RETURNS

UNBALANCED

DO NOT OPEN

TIP + RING - SLEEVE GND

MIXER LINKING

UNBALANCED 10KΩ

2KΩ

+4db

230V(0.15A)

50/60Hz 30W

1.Fuse sled - This contains a fuse holder and shows the currently selected voltage rating for your PL 1602. Make sure the voltage rating is correctly set before powering up! Fuse ratings are: 0.3 amp for 115 VAC and 0.15 amp for

230VAC. The voltage rating will normally be preset correctly at the factory and will require no adjustment unless you use the PL 1602 in a country other than the one in which you purchased the unit. For information on how to change the voltage rating, see Appendix B on page 25.

2.AC input - Connect the supplied standard 3-pin “EEC” plug here.

3:Power on-off switch - As you may have guessed, this is what you use to turn the PL 1602 on and off. To avoid potential damage to your speakers, turn the mixer on before you turn on any connected power amps— and turn it off after the power amps are turned off.

4:Line inputs - Use these electronically balanced 1/4" jacks to connect line- level sources such as synthesizers, drum machines, CD players, tape decks, or effects processors to any of the PL 1602’s sixteen channels. Use balanced three-conductor cabling and Tip/Ring/Sleeve (TRS) plugs wherever possible (unbalanced two-conductor plugs can also be inserted into these inputs, but you’ll get better signal quality and less outside noise and hum if you use balanced lines). When connecting monophonic (as opposed to stereo) signal sources, use the left (odd-numbered) inputs; the Balance control for that channel pair will then act as a constant level pan control— see the “Using the Balance Control” section on page 16 for more information. The “Connecting The PL 1602” section on page 9 provides more information on how best to use channel inputs. WARNING: Do not connect the channel 1 or 3 line input if you already have something connected to that channel’s microphone input (see #5 on the next page); these channels are designed to accept only one source or the other.