ProForm PMTL32706.0 user manual Are not Connected PROPERLY, Console MAY be Damaged When

5. Set the Console (43) face down on a soft surface	5		2
to avoid scratching the Console. Next, set one of
		71
the Handrails (71) on the Console as shown.
				2
Attach the Handrail with three 3/4” Screws (2).
Make sure that the console wire is not					2
pinched. Start all three Screws before tight-
ening any of them. Do not overtighten the	Console Wire
Screws.
Then, attach the other Handrail (not shown) to		43
the other side of the Console (43) as described
above.
With the help of a second person, raise the
Uprights (not shown) to the vertical position.
6. Remove the plastic tie securing the Wire	6
Harness (42) to the right Upright (69). Insert the
		43
colored tie on the Wire Harness up through the
large holes in the right Handrail (71) as shown.
Then, pull the Wire Harness up through the
holes.
Next, set the Handrails (71) with the Console
(43) on the Uprights (69). Make sure that the			Colored Tie
Wire Harness (42) and the console wire are
not pinched. Untie and discard the colored wire.	71		Console
Then, connect the Wire Harness (42) to the con-			Wire
sole wire. Make sure to connect the connec-			Console
tors properly (see the inset drawing). The	42		Wire
connectors should slide together easily and
snap into place. If the connectors do not slide
together easily and snap into place, turn one			42
connector and try again. IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE			69
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Insert the connectors
and the excess wire into the Console (43).
7. Tighten the four Handrail Bolts (37) with the four	7
1/4” Star Washers (95) into the Uprights (69) and
the Handrails (71). Start all four Handrail Bolts
before tightening any of them.
	71
			37
	37	95	95
			71		95	37
			69
			37	95	69
	8