Pioneer HTZ363DVD, HTZ767DVD, HTZ565DVD, S-DV2T Other connections Connecting using Hdmi, About Hdmi

Other connections 09

Connecting using HDMI

If you have a HDMI or DVI (with HDCP) equipped monitor or display, you can connect it to this player using a commercially available

HDMI cable for high quality digital video.1

See About HDMI below for more about the HDMI connection.

•Use an HDMI cable to connect the HDMI OUT interconnect on this player to an HDMI interconnect on a HDMI-compatible monitor.

To HDMI

connector

HDMI-compatible display

	ANTENNA		C /
		COMPONENT	P		LINE		R FRONT L
		VIDEO	C /	IN	OUT			CENTER
		VIDEO		L		L	CONTROL
AM LOOP	FM		P				OUT
	UNBAL 75 Ω
	IN	S-VIDEO	Y	R		R
							R SURROUND L	SUB
	MCACC	VIDEO OUT			AUDIO			WOOFER
HDMI OUT SETUP MIC CONTROL							SPEAKERS (4 Ω - 6 Ω)

•The arrow on the cable connector body should be face up for correct alignment with the connector on the player.

You can also adjust the HDMI settings for resolution and color. For more on these settings see Video Output settings on page 29.

Switching the HDMI audio setting

To listen to audio from the HDMI interconnect, make sure you’ve specified the HDMI audio output setting.

1	Switch the system into standby.
2	Press SHIFT+SETUP and use		to
choose HDMI OUT then press ENTER.
3	Use	to choose the setting you want
then press ENTER.

•AUDIO ON – Audio signals are output through the HDMI interconnect

•AUDIO OFF – Switches off HDMI audio

Resetting the HDMI connection

If you get an error message (the display shows HDMI ERR) or if the screen goes blank (for example, after changing the resolution), check the troubleshooting guide on page 46. If this doesn’t solve the problem, follow the steps below to reset the HDMI connection.

1 Switch the system into standby.

2 Press SHIFT+SETUP and use	to
choose HDMI INI then press ENTER.

The system will restart and the HDMI settings are automatically reset to the factory defaults. See Video Output settings on page 29 for more on these settings.

About HDMI

HDMI (High Definition Multimedia Interface) supports both video and audio on a single digital connection for use with DVD players, DTV, set-top boxes, and other AV devices. HDMI was developed to provide the technologies of High Bandwidth Digital Content Protection (HDCP) as well as Digital Visual Interface (DVI) in one specification. HDCP is used to protect digital content transmitted and received by DVI-compliant displays.

English Deutsch Français Italiano Nederlands Español

Note

1 • An HDMI connection can only be made with DVI-equipped components compatible with both DVI and High Bandwidth Digital Content Protection (HDCP). If you choose to connect to a DVI connector, you will need a separate adaptor (DVI HDMI) to do so. A DVI connection, however, does not support audio signals. Consult your local audio dealer for more information.

•Depending on the component you have connected, using a DVI connection may result in unreliable signal transfers.

•When you change the component connected to the HDMI output, you will also need to change the HDMI settings to match the new component (see Video Output settings on page 29 to do this).

35

En