Radio Shack 33-3025 manual Installing Batteries, Specifications

33-3025.fm Page 2 Tuesday, August 10, 1999 12:21 PM

INSTALLING BATTERIES

You need two AAA batteries (not supplied) to power your microphone. We recommend al- kaline batteries, such as RadioShack Cat. No. 23-555. To install the batteries, slide them into the battery holder on the bottom of the microphone stand, according to the po- larity shown in the holder.

After you install the batteries, plug the micro- phone’s cable into your computer’s sound board.

SPECIFICATIONS

Microphone Type	Electret Condenser
Polar Pickup Pattern	Unidirectional (Cardioid)
Impedance	Less than 5.0 kΩ
Sensitivity (at 1 kHz)	–27 dB +4/–7.5 dB (10 kΩ Z Load)
Power	3 Volts DC (Two AAA Batteries)
Current Drain	300 μA DC Maximum
Connector	1/8-Inch (3.5 mm) Stereo Phone Plug
Connector Wiring	Tip: Signal Positive
	Ring: No Connection
	Sleeve: Signal Negative
Size (HWD)	111/2 × 5 × 7/8 Inches (292 × 127 × 22 mm)
Weight (Including Cable, Without Batteries)	3.2 oz (91 g)

Specifications are typical; individual units might vary. Specifications are subject to change and improvement without notice.

RadioShack

A Division of Tandy Corporation

Fort Worth, Texas 76102

6/96 Printed in the USA