Pioneer HTZ656DVD manual Additional information Chapter, Optional system settings

10Additional information

Chapter 10

Additional information

Optional system settings

All the available settings in the standby setup

menu are listed below1. See the notes in each section for more information about the settings. The first setting in each section is the default.

1 Switch the system into standby.

2 Press SHIFT+SETUP and use then ENTER to choose the setting you want to adjust.

The available settings are shown in the front panel display.2

TV system setting

Not applicable to the Taiwanese model

The default setting of this system is AUTO, and unless you notice that the picture is distorted when playing some discs, you should leave it set to AUTO. If you find picture distortion with some discs, set the TV system to match your country or region’s system. However, this may restrict the kinds of disc you can watch. See the table for the kinds of discs compatible with

each setting (AUTO, PAL and NTSC).3

• After using to choose TV SYS (step 2 above), press ENTER to change the TV system as follows:

3 Use to adjust then press ENTER to confirm and exit.

System demo setting

Switches the automatic demo feature on or off (this starts when you plug in for the first time):

•DEMO ON – Switches the demo feature on.

•DEMO OFF – Switches the demo feature off.

Frequency step setting

If you find that you can’t tune into stations successfully, the frequency step may not be suitable for your country/region.

•AM 9K

•AM 10K

• AUTO	NTSC
• NTSC	PAL
• PAL	AUTO

The system automatically switches on and you’ll see the new TV system setting in the

display after seeing WELCOME.4

		Player setting
Media Type	Format	NTSC	PAL	AUTO
DVD/Super VCD/	NTSC	NTSC	PAL	NTSC
Video CD/DivX	PAL	NTSC	PAL	PAL
Video
CD/MP3/WMA/	—	NTSC	PAL	NTSC or
MPEG-4 AAC/				PAL
JPEG/no disc

Note

1The HDMI features are explained in Connecting using HDMI on page 34.

2The setup menu is exited automatically after 5 minutes of inactivity.

3Most models of the newly developed countdown PAL TV system detect 50 Hz (PAL)/60 Hz (NTSC) and automatically switch vertical amplitude, resulting in a display without vertical shrinkage. However, in some cases, the image may appear without col- or. If your PAL TV does not have a V-Hold control, you may not be able to watch NTSC discs because of picture roll. If the TV has a V-Hold control, adjust it until the picture stops rolling. On some TVs, the picture may shrink vertically, leaving black bands at the top and bottom of the screen.

4 You have to switch the player into standby (press STANDBY/ON) before each change.

36

En