Roland owner manual Power Supply, Placement, Maintenance, For HP103-PE

Page 5

IMPORTANT NOTES

291b

In addition to the items listed under “IMPORTANT SAFETY INSTRUCTIONS” and “USING THE UNIT SAFELY” on pages 2,

3 and 4, please read and observe the following:

Power Supply

301

•Do not connect this unit to same electrical outlet that is being used by an electrical appliance that is controlled by an inverter (such as a refrigerator, washing machine, microwave oven, or air conditioner), or that contains a motor. Depending on the way in which the electrical appliance is used, power supply noise may cause this unit to malfunction or may produce audible noise. If it is not practical to use a separate electrical outlet, connect a power supply noise filter between this unit and the

electrical outlet.

307

•Before connecting this unit to other devices, turn off the power to all units. This will help prevent malfunctions

and/or damage to speakers or other devices.

308

•Although the LCD and LEDs are switched off when the POWER switch is switched off, this does not mean that the unit has been completely disconnected from the source of power. If you need to turn off the power completely, first turn off the POWER switch, then unplug the power cord from the power outlet. For this reason, the outlet into which you choose to connect the power cord’s plug should be one that is within easy reach.

Placement

351

•Using the unit near power amplifiers (or other equipment containing large power transformers) may induce hum. To alleviate the problem, change the orientation of this unit; or move it farther away from the source of

interference.

352a

•This device may interfere with radio and television reception. Do not use this device in the vicinity of such

receivers.

352b

•Noise may be produced if wireless communications devices, such as cell phones, are operated in the vicinity of this unit. Such noise could occur when receiving or initiating a call, or while conversing. Should you experience such problems, you should relocate such wireless devices so they are at a greater distance from this

unit, or switch them off.

354b

•Do not expose the unit to direct sunlight, place it near devices that radiate heat, leave it inside an enclosed vehicle, or otherwise subject it to temperature extremes. Also, do not allow lighting devices that normally are used while their light source is very close to the unit (such as a piano light), or powerful spotlights to shine upon the same area of the unit for extended periods of time. Excessive heat can deform or discolor the unit.

355b

•When moved from one location to another where the temperature and/or humidity is very different, water droplets (condensation) may form inside the unit. Damage or malfunction may result if you attempt to use the unit in this condition. Therefore, before using the unit, you must allow it to stand for several hours, until the condensation

has completely evaporated.

356

•Do not allow rubber, vinyl, or similar materials to remain on the unit for long periods of time. Such objects can

discolor or otherwise harmfully affect the finish.

358

•Do not allow objects to remain on top of the keyboard. This can be the cause of malfunction, such as keys ceasing

to produce sound.

359

•Do not paste stickers, decals, or the like to this instrument. Peeling such matter off the instrument may damage the exterior finish.

Maintenance

401b

•To clean the unit, use a dry, soft cloth; or one that is slightly dampened. Try to wipe the entire surface using an equal amount of strength, moving the cloth along with the grain of the wood. Rubbing too hard in the same area can

damage the finish.

402

•Never use benzine, thinners, alcohol or solvents of any kind, to avoid the possibility of discoloration and/or

deformation.

403

•The pedals of this unit are made of brass.

Brass eventually darkens as the result of the natural oxidization process. If the brass becomes tarnished, polish it using commercially available metal polisher.

For HP103-PE

•Since your piano has a polished finish that is as delicate as that found on finely crafted wooden furniture, it needs careful, periodic care. A few important suggestions concerning the proper care of the unit follow.

•For dusting, wipe the instrument with a soft cloth that has been soaked with water, then squeezed dry.

Be sure to wipe gently. Even the tiniest grains of sand or grit can leave scratches on the surface if too much force is applied while wiping.

Do not use any cleaners or detergents, since they might deteriorate the surface of the cabinet, and produce cracks. Do not use dusting cloths that contain chemicals.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Pursuing the Playing Feel of a Grand Piano Main FeaturesComfortable for Use with Headphones Important Safety Instructions 001 002a Protect the unit from strong impact. Do not drop it Placement Power SupplyMaintenance For HP103-PEAdditional Precautions Contents Front Panel Panel DescriptionsInput jacks Rear PanelConnecting the Power Cord Connecting the Pedal CordSetting Up the Music Rest Before You Start PlayingTurning the Power On and Off Connecting HeadphonesUsing the Music Holders Using the Headphones HookAbout the Pedals Adjusting the Sound’s Volume and BrillianceAbout the Adjuster Selecting a Song and Playing It Listening to Internal SongsStopping the playback Choosing the song to play backPlaying Back the Tone Demo Songs Listening to the Demo SongsPress the Demo button Stopping the Tone Demo SongsListening to a Demo of the Functions Button assigned function Demo content Grand SpacePress any of the following buttons Stopping the Demo of the FunctionsPerforming with a Variety of Sounds PerformanceSelecting a tone group Selecting variation tonesIndicator Settings Adjusting the Keyboard Touch Key TouchPress the Key Touch button RedHold down the Grand Space button, and press the or + button Changing the Grand Space SettingsAdding a Sense of Depth to the Sound Grand Space Adding the Right Sense of Depth for Headphones Grand Space Changing the Dynamic Emphasis Settings Press the Dynamics button, getting its indicator to lightAdding Liveliness to the Sound Dynamic Emphasis Hold down the Dynamics button, and press the or + buttonAdding Reverberation to the Sound Reverb Applying Effects to the SoundPress the Reverb button Changing the depth of the reverb effectFig.panel2-6 Transposing the Key of the Keyboard TransposePlaying Two Sounds Together Dual Play Adjusting the Volume Balance in Dual Play Dual BalanceHold down the Transpose button and press the Split button Press the or + button to change the valueChanging tone played by the left hand Press the Split buttonChanging tone played by the right hand Press the Tone button2, 4 1 Using MetronomeChanging the Keyboard’s Split Point Sounding the MetronomeChanging the beat of metronome Changing the Metronome VolumeHold down the Song/Tempo button, and press the or + button Stopping the metronomeFig.panel3-1 To exit the function, press the Split buttonAdding a Count-in to Match the Timing Count-In Changing the TempoSelecting the part that you yourself will play Playing Each Hand SeparatelyPlaying back a song Stopping the songIf you see the following Recording Your Performance6,7,8 5,7 Recording a New Song3 6,7,8 4,7 Recording Along with a SongSelecting the song to record Selecting the track to recordAs necessary, turn on the metronome p Press the Rec button Selecting and Recording the Track for Each Hand Separately5,6 2,5 Erasing a Performance from the Specified Track Erasing Recorded PerformancesErasing a Song Hold down the Song/Tempo button and press the Rec buttonChanging the Damper Pedal’s Resonance Changing Various SettingsMaking Detailed Settings Function Tonic Tuning to Other Instruments’ Pitches Master TuningChanging the Temperament Applying the Damper Pedal to Left-hand Keyboard Area Setting the Tuning Curve Stretch TuningChanging How Grand Space is Applied Grand Space Mode Disabling Everything Except Piano Play Panel Lock Using the V-LINK functionHow to Use the V-LINK Connecting to a Computer Connecting External DevicesConnecting to Audio Equipment Connection ExamplesWhat’s MIDI? Connecting Midi DevicesSetting various functions Switching Local Control on Off Midi Send Channel SettingsValue Power-up default setting Transmitting a Performance You RecordedCase Cause/Remedy TroubleshootingDisplay Meaning Error Messages/Other MessagesSplit Off Split On Tone ListSong Song Name Composer Copyright Internal Song ListProfile John Maul Internal Song ListHold down the button and press the or + button Easy Operation ListMidi Implementation Chart Main Specifications Midi IndexMemo Memo Memo Information Avis 03679534 ’05-4-3N
Top Page Image Contents