KXB20 Control Panel
KXB20
1.Input 1: ¼-inch input that is intended for bass guitars but will accept other instruments as well.
2.Input 2: ¼-inch input that is wired in parallel with Input 1. Both inputs may be used at the same time, if desired.
3.Volume: Adjust this control to set the desired volume level of the amplifier. Note: If you are using an instrument with a built-in active preamp, set its level to mid-position before increasing its volume or distortion may occur.
4.Bass: This active control adjusts the lower frequencies to provide rich, full bass tones. It will boost or cut by 14 dB at
60Hz.
5.Lo-Mid:This control adds thickness and body to your tone. It will boost or cut by 12 dB at 340 Hz.
6.Hi-Mid:This control adds punch to your overall tone. It will boost or cut by 10 dB at 2 kHz.
7.Treble: Increasing this control will add presence and attack to your bass tone. It will boost or cut by 15 dB at 10 kHz, perfect for enhancing “slap” and pick playing.
8.Aux In: This is a 3-conductor, 1/8-inch, stereo jack that allows playback from a Compact Disc, MP3 player or other audio device. The overall volume level will be determined by the audio device, so start with lower volume levels and increase as needed.
9.Headphones: This is a 3-conductor, 1/8-inch input jack intended for headphone use. The amplifier’s internal speaker is disconnected when this jack is used.
10.Power Switch: This dual-function component is both an On/Off power switch and a status indicator light. When illuminated, it shows that your amplifier is ready to be played. To turn amplifier on, press switch upward. To turn amp off, press switch downward.
