Fishman AGP-2, ABGP owner manual Wiring the Transducer, Mounting the Battery Holder

AGP-2 / ABGP

holes from the inside of the guitar. Next, measure the length of the threaded bushing that protrudes out from the side of the instrument. From this mea- surement, subtract the thickness of the outside hardware (hex nut and finish washer).

5. WIRING THE TRANSDUCER FIG. 2

Remove the cover from the AGP-2 Preamp.

Locate the terminal block

with two sections to be used to connect the transducer leads (see

Figure 2). Thread the transducer wire through

the rubber grommet

where the wire harness enters the preamp. Strip

and tin the signal and ground wires from the transducer and connect them to the terminal block as shown in Figure 2. Check for shorts. Replace the cover and screws (SEE NEXT SECTION), being careful to engage the grom- met in the appropriate slot.

6. MOUNTING THE BATTERY HOLDER

The AGP-2 is supplied with a battery holder that can be attached to the pre- amp cover with the screws provided (see Figure 3), or be attached to the neck block (see Section 6a).

Be sure to check and adjust the fit of the battery in the holder before installing the AGP-2 Preamp inside the instrument.

6a. OPTIONAL BATTERY HOLDER MOUNT

Cut a block of 1/4” plywood approximately 1-1/2” x 2-1/2” (40mm x 65mm). Using two Number 4 pan-head sheet metal screws (1/4" length), attach the battery holder to the wooden block. The assembly can then be attached to the neck block with wood glue, double sided tape, or Velcro.

4