Fishman ABGP, AGP-2 owner manual Knob Alignment, Ready for USE

Page 7

ONBOARD ACOUSTIC GUITAR PREAMP

11. KNOB ALIGNMENT

The stacked knob set controls treble boost & cut (small knob) and bass boost & cut (large knob). Both knobs have a center-detent to indicate flat position. Place the bass (large outer ring) knob onto the stacked shaft so that the two inner protrusions slide into the corresponding slots on the outer shaft. Now place the smaller treble knob onto the inner shaft. The white position markers should align with each other in the center detent position. Now place the large volume knob onto the appropriate shaft; rotate the knob and remove to re-position the line if necessary for the desired sight refer- ence position.

12. READY FOR USE

The power is switched on only when a 1/4” mono guitar cable is plugged into the out- put jack. The AGP-2 features a “soft” turn on mode. This means that the unit powers up gradually over several seconds once the instrument is plugged in.

 

SPECIFICATIONS

 

 

SYSTEM GAIN

9 dB (input to output at 1 kHz)

 

 

 

All tone controls flat.

 

 

Maximum input voltage before clipping with all controls at full boost

 

 

 

.8V P-P

 

 

AGP-2 TONE CONTROLS

 

 

 

Treble: Boost and Cut

± 3dB at 1700 Hz

 

 

 

± 14dB at 20 kHz

 

 

Bass: Boost and Cut

± 3dB at 350 Hz

 

 

 

± 8dB at 50 Hz

 

 

Frequency Response

20 Hz to 20 kHz ±2dB All tone controls flat

 

 

ABGP TONE CONTROLS

 

 

 

Treble: Boost and Cut

± 3dB at 850 Hz

 

 

 

± 14dB at 20 kHz

 

 

Bass: Boost and Cut

± 3dB at 350 Hz

 

 

 

± 8dB at 50 Hz

 

 

Frequency Response

20 Hz to 20 kHz ±2dB All tone controls flat

 

 

POWER SUPPLY

9 Volts (battery not included)

 

 

Battery Life

150 hours continuous use (alkaline battery)

 

 

 

 

 

All specifications subject to change without notice.

 

7

Image 7
Contents Onboard Acoustic Bass Guitar Preamp Onboard Acoustic Guitar PreampLocation AGP-2 / AbgpSpacer Block TemplatePreparing the Spacer Mounting the Battery Holder Wiring the TransducerPrepare the Endblock Mount the PreampFasten the Jack in the Endpin Hole Wiring the Output JackReady for USE Knob AlignmentReturn Policy Limited Warranty