Effects Loop
The Effects Loop can be used to insert signals from external sources such as a Digital Effects or Equalizers into the signal path. The loop is inserted after the tone and vol- ume controls. To use the Effects Loop connect the EFX Sen jack to the input of the equalizer or effects unit. Connect the output of the equalizer or effects unit to the EFX RTN jack to complete the loop.
Linking Together Multiple Wedges
When the Yorkville 100kw Power Wedge is used with a line level input for stage moni- tor purposes, it’s possible to link together several units by using the inputs on Channel
2. Insert the mixed signal from a mixing console into either of the two phone jacks (on Channel 2). It is possible to use the remaining phone jack input on Channel 2 as an out- put to link to another Yorkville 100kw.
Please note: that only information being sent to the input of Channel 2 will be linked.
Phones
Headphones can be connected to the Yorkville 100kw by inserting a headphone plug into the Pones jack located on the front panel. While headphones are connected, the internal speaker is disconnected. Always use stereo headphones. The audio heard through stereo headphones will be a mono signal separated into the two earpieces.
Caution: Always exercise caution when using headphones to avoid permanent hearing loss.
Power Switch
When the Yorkville 100kw Power Wedge is turned on, the LED beside the power switch will be illuminated.
Specifications
Power @ min. impedance (Watts) Minimum Impedance (ohms)
Burst Power - 2 cycle Speaker Configuration - LF (Size / Power) Speaker Configuration - HF (Size / Power)
Input Channels Channel 1 - inputs Channel 1 - controls Channel 2 - inputs Channel 2 - controls Main Tone Controls Input Sensitivity (mV)
Line Out (type / configuration) Line Out Sensitivity (Vrms)
Effects Loop / Location Effects Return Sensitivity (Vrms)
LED Indicators Limiter / Switchable Headphone Jack Dimensions (DWH, inches) Dimensions (DWH, cm) Weight (lbs / kg)
100
4
115 Watts
12 inch / 100 Watts
1 inch / 30 Watts
2
XLR, 1/4 inch TRS Volume
2x 1/4 inch TRS, RCA Volume
Low, High
ch. 1 XLR=3 Phone=10, ch.2 Phone=75 RCA=150 1/4 inch / Front (Effects Send)
1
Yes / Front 1
Power
Yes / No Yes
19 x 17 x 19
48 x 43 x 48
39 / 17.7
2