Introduction, Inputs, Tone Controls, Channel

CHANNEL1 BAL LINE IN			MIC	CHANNEL 2			BAL LINE IN	CD / LINE	LOW		HIGH
4	5	6		4	5	6		3	3		3	3
4		6		4		6		3	3		3	3
3		7		3		7		6		6	6
2		8		2		8		9		9	9
1		9		1		9		12		12	12
0		10		0		10		15	15		15	15

KW		POWER
6	BAL
6
9
12
EFX SEND	EFX RTN	PHONES

230V

50Hz

0.5A

Yorkville

120VAC

60Hz

1.0A

Introduction

The multi-purpose Yorkville 100kw Power Wedge mixer/amp has been designed to pro- duce the most performance possible in a compact combo format. The Yorkville 100kw is appropriate to use with just about anything that produces an audio signal. This includes such items as professional or home keyboards, acoustic guitars (with pickups), micro- phones, or other audio sources such as CD-players or even cassette decks. No matter what, the Yorkville 100kw Power Wedge will sound great and be dependable for years to come.

Inputs

The Yorkville 100kw has two input channels, both input channels can be used simulta- neously. As an example, you could use a microphone on Channel 1 and a stereo key- board on Channel 2. You can balance the loudness of the two sources by adjusting each individual channel’s volume control.

Channel 1

Channel 1 is optimized for microphones, however the phone jack can also accept line level inputs from an acoustic guitar (with pickup), electronic keyboard, CD-player or other audio sources. This channel offers more gain than Channel 2, it’s advised that the source with the lower level output be connected to Channel 1. Adjust the volume con- trol for the level of sound desired.

This channel’s 1/4-inch input is balanced (T.R.S. or Tip/Ring/Sleeve, +/-/gnd). The phone jack can also use regular, unbalanced, cables. For best results, and reduced noise, it is advised that you use balanced (stereo) cables for interconnection wherever possible.

•Do Not use both the phone and XLR inputs on Channel 2 at the same time.• The signals will be attenuated!

Channel 2

Channel 2 - This channel is optimized for line level signals such as an electronic key- board, CD-players, cassette decks, or other audio sources. The channel also sums stereo signals properly for use with this single amplifier system. You can utilize this feature either by using the two phone jacks or the two RCA jacks (both sets of jacks can be used at the same time). Adjust the Channel 2 volume control for the level of sound desired.

Tone Controls

The Low and High controls allow a wide range of tonal adjustment. The tone controls affect the sound output from both channels. Increase or decrease the Low control to affect low frequency information and the High control for high frequency information.

Please note: Due to the great variance between possible signal sources, it may be possible to dis-

tort the signal by adjusting the Low or High controls.