Hughes & Kettner 400 manual Mains Socket, Rear Panel

BASSBASE 400 - MANUAL

REAR PANEL:

FOOTSWITCH VARIMETRIC: Connect a standard single-channel footswitch to this jack. If you use a HUGHES & KETTNER FS-1, its LED will illuminate when you activate the VARIMETRIC EQ.

I

FOOTSWITCH FX LOOP: Connect a standard single- channel footswitch to this jack. If you use a HUGHES

&KETTNER FS-1, its LED will illuminate when you activate the FX LOOP.

TUNER OUT: Output jack for an external tuning device.

LINE OUT: The full-range signal from this jack can be sent to a mixing console or additional power amp.

RETURN: Connect this jack to the FX processor’s OUTPUT jack.

-10 db SWITCH: Press this damping switch to lower the signal level sent to the input of effects processors expecting an instrument-level signal such as stomp boxes.

‘t I

C

MAINS SOCKET:

Connect the included power cable (Euro- norm) to this socket. The fuse bracket is integrated in the socket; make certain you use specified replacement fuses only!

SEND: Connect this jack to the FX processor’s INPUT jack.

SPEAKER OUTPUTS: Output jacks for connecting external bass speaker cabinets (these jacks are wired in parallel). The overall impedance rating is 4 ohms. For instance, you can connect one 500 watt cabinet with a minimum rating of 4 ohms or two 500 watt cabinets with a minimum rating of 8 ohms each. If you operate the BASSBASE 400 at a higher impedance rating, power output will decrease accordingly.

It is very important that you heed the maximum rated handling capacity of any speaker cabinets you choose to connect, especially if you have borrowed them from someone you want to remain friends with.