Ampeg manual SVT-2 PRO Bass Amplifier

Page 2

SVT-2 PRO Bass Amplifier

TABLE OF CONTENTS

 

Important Safeguards and Precautions

. . . . . . . .2

Introduction

. . . . . . . .3

Features

. . . . . . . .3

System Block Diagram

. . . . . . . .3

The Front Panel Controls and Their Use

. . . . . . . .4

The Rear Panel

. . . . . . . .5

Some Suggested Settings

. . . . . . . .6

Changing the Tubes

. . . . . . . .7

Setting Tube Bias

. . . . . . . .7

Troubleshooting

.back cover

Technical Specifications

.back cover

Important Safeguards and Precautions:

All Ampeg products are designed for continuous safe operation, as long as common sense is used and steps are taken to help avoid certain problems. Abiding by the following rules can help prevent damage to your preamp, yourself and others.

The amplifier is equipped with a three-pronged AC power cord. To reduce the risk of electrical shock, NEVER remove or otherwise attempt to defeat the ground pin of the power cord.

Connect the amplifier ONLY to a properly grounded AC outlet of the proper voltage for your amp.

Avoid sudden temperature extremes, rain and moisture. Also, avoid sudden and intense impact. (If the unit has been subjected to any of the preceding abuses, have it looked at by an authorized service center.)

Never set the amplifier on a support that might give out under its weight.

When using tall or stacked speaker cabinets, use them ONLY on a level surface. NEVER set tall or stacked cabinets on a surface with more than a five degree incline since tipping or falling could occur, possibly caus- ing serious injuries.

Always keep the total speaker impedance at or above the rated load.

Unplug the amplifier before cleaning it. NEVER spray liquid cleaners onto the amp. Wipe it with a slightly dampened, lint-free cloth to remove dirt and film.

Don’t use the amplifier if it has sustained damage to the chassis, controls, or power cord. Refer the unit to an authorized service center for inspection.

Amplifiers capable of producing high volume levels are also capable of inflicting permanent hearing loss or damage, if the exposure to such levels is prolonged. Such damage is progressive and irreversible!

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,

DO NOT REMOVE COVER.

NO USER-SERVICEABLE PARTS INSIDE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

ATTENTION

RISQUE D'ELECTROCUTION

NE PAS OUVRIR

ATTENTION: POUR REDUIRE D'ELECTROCUTION NE PAS

ENLEVER LE COUVERCLE. AUCUNE PIECE INTERNE N'EST REPRABLE

PAR L'UTILISATEUR. POUR TOUTE REPARATION, S'ADRESSER A UN

TECHNICIEN QUALIFIE.

VORSICHT

ELEKTRISCHE SCHLAGGEFAHR

NICHT OFFENEN

VORSICHT: ZUR MINIMIERUNG ELEKTRISCHER SCHLAGGEFAHR NICHT

DEN DECKEL ABENHMEN. INTERNE TEILE KONNEN NICHT VOM

BENUTZER GEWARTET WERDEN. DIE WARTUNG IS QUALIFIZIERTEM

WARTUNGSPERSONAL ZU UBERLASSEN.

THIS EQUIPMENT HAS BEEN DESIGNED AND ENGINEERED TO PROVIDE SAFE AND RELIABLE OPERATION. IN ORDER TO PROLONG THE LIFE OF THE UNIT AND PREVENT ACCIDEN- TAL DAMAGES OR INJURY, PLEASE FOLLOW THESE PRECAUTIONARY GUIDELINES:

WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT OPEN CHASSIS; DO NOT DEFEAT OR REMOVE THE GROUND PIN OF THE POWER CORD; CONNECT ONLY TO A PROP- ERLY GROUNDED AC POWER OUTLET.

CAUTION: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.

CAUTION: NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

CAUTION: OUR AMPLIFIERS ARE CAPABLE OF PRODUCING HIGH SOUND PRESSURE LEVELS. CONTINUED EXPOSURE TO HIGH SOUND PRESSURE LEVELS CAN CAUSE PERMANENT HEARING IMPAIRMENT OR LOSS. USER CAUTION IS ADVISED AND EAR PROTECTION IS RECOMMENDED IF UNIT IS OPERATED AT HIGH VOLUME. The chart below shows the U.S. Government Occupational Safety and Health Administration (OSHA) regulations which were in effect at the time of this publication for permissible noise exposure, per 29CRF1910, Table G-16.

SOUND LEVEL dBA

DURATION PER DAY

SOUND LEVEL dBA

DURATION PER DAY

SLOW RESPONSE

IN HOURS

SLOW RESPONSE

IN HOURS

 

 

 

 

90

8

102

1-1/2

92

6

105

1

95

4

110

1/2

97

3

115

1/4 or less

100

2

 

 

According to OSHA, any exposure in excess of those listed above could result in some hearing loss.

EXPLANATION OF

"DANGEROUS VOLTAGE"

= "DANGER HAUTE TENSION"

GRAPHICAL SYMBOLS:

"GEFAHLICHE SPANNUNG"

 

"IT IS NECESSARY FOR THE USER TO REFER TO THE INSTRUCTION MANUAL"

="REFERREZ-VOUS AU MANUAL D'UTILISATION"

"UNBEDINGT IN DER BEDIENUNGSANLEITUNG NACHSCHLAGEN"

2

Image 2
Contents Bass Amplifier Ampeg is Proudly Made in AmericaSVT-2 PRO Bass Amplifier Features An Introduction to your new Ampeg SVT-2 PRO Bass AmplifierFront Panel Controls and Their Use Ed instrument cableSVT-2 PRO Bass Amplifier Some Suggested Settings RockSetting Tube Bias Changing the TubesTechnical Specifications Troubleshooting