B4R Bass Amplifier
Connections:
In the example shown below, the B4R’s two internal power amplifiers are bridged together to produce maximum output power. Set the Stereo/Mono Bridge switch to the IN (Mono Bridged) position and connect the system as follows:
Mono
Bridged
B4R
MONO | MONO |
BRIDGE | |
BRIDGE |
|
1 | 1 |
|
IN |
(MONO)
TO
INPUT
JACK
FULL RANGE CABINET(S)
NOTE: BE ABSOLUTLEY CERTAIN THAT THE CABINET(S) ARE ABLE TO HANDLE THE EXTREMELY HIGH OUTPUT POWER OF THE AMP IN THIS MODE!
1:Connect a heavy duty speaker cable terminated with a Speakon® connector or dual banana plugs from the B4R’s Mono Bridge / Biamp Output jack to the input jack of a speaker cabinet capable of handling the extremely high output power. (Speakon® : pin 1 +, 2 +; Banana: Mono +, Mono
In the example shown below, the B4R’s two internal power amplifiers will each power a set of full range cabinets.
Set the Stereo/Mono Bridge switch to the OUT (Stereo) position and connect the system as follows:
Dual
Mono
B4R
PWR | PWR | PWR | PWR | |
AMP B | AMP A | |||
AMP B | AMP A | |||
|
| |||
|
| 2 |
| |
2 | 1 |
| 1 |
OUT |
(STEREO) |
TO
INPUT
JACK
TO
INPUT
JACK
FULL RANGE CABINET(S)
FULL RANGE CABINET(S)
1:Connect a speaker cable from the B4R’s Power Amp A Speaker Output jack to the input jack(s) of a set of full range speakers.
2:Connect a speaker cable from the B4R’s Power Amp B Speaker Output jack to the input jack(s) of another set of full range speakers.
In the example shown below, the B4R’s two internal power amplifiers will power both a full range cabinet and a low frequency cabinet. The crossover point is determined by the Biamp Frequency control (#16).
Set the Stereo/Mono Bridge switch to the OUT (Stereo) position and connect the system as follows:
Biamp: Full
Range / Lows
B4R
BIAMP | 1 |
| ||
LO OUT |
| |||
PWR | PWR | PWR | PWR | |
AMP B | AMP A | |||
AMP B | AMP A | |||
|
| |||
|
| 3 | PWR | |
|
| AMP A | ||
|
|
| P.A. IN | |
3 | 2 | OUT | 2 | |
|
|
| ||
|
| (STEREO) |
| |
TO
INPUT
JACK
TO
INPUT
JACK
FULL RANGE CABINET(S)
LOW FREQ. CABINET(S)
1:Connect a shielded cable from the B4R’s Biamp Low Out jack to its Power Amp A Power Amp In jack.
2:Connect a speaker cable from the B4R’s Power Amp A Speaker Output jack to the input jack of the low frequency cabinet(s).
3:Connect a speaker cable from the B4R’s Power Amp B Speaker Output jack to the input jack of the full range cabinet(s).
8