Behringer BX4410A manual Control Elements, Front panel, Online registration

ULTRABASS BX4410/BX4410A

1.2.3 Online registration

Please do remember to register your new BEHRINGER equipment right after your purchase by visiting www.behringer.com (alternatively www.behringer.de) and kindly read the terms and conditions of our warranty carefully.

Should your BEHRINGER product malfunction, our goal is to have it repaired as quickly as possible. To arrange for warranty service, please contact the retailer from whom the equipment was purchased. Should your BEHRINGER dealer not be located in your vicinity, you may directly contact one of our subsidiaries. Corresponding contact information is included in the original equipment packaging (Global Contact Information/European Contact Information). Should your country not be listed, please contact the distributor nearest you. A list of distributors can be found in the support area of our website (www.behringer.com).

Registering your purchase and equipment with us helps us process your repair claims quicker and more efficiently.

Thank you for your cooperation!

2.CONTROL ELEMENTS

2.1Front panel

Fig. 2.1: BX4410/BX4410A front panel (section 1)

The LEVEL VU meter reads the level that is applied to the preamp circuitry of the BX4410/BX4410A.

+If the GAIN control is set fully counterclockwise, the VU meter reads the input level only. Selecting

“Active” instead of “Passive” is recommended if the input level appears too high (in the right-hand third of the VU meter). Use the GAIN control to set the amplifier properly (so that the meter is in the mid region). The overall volume can be adjusted

with the OUTPUT control .

These are the inputs for your electric bass guitar. The PASSIVE jack is for passive basses, the ACTIVE jack for active instruments with high output levels. The ACTIVE jack features 10 dB less gain.

Use the GAIN control to determine the input gain on your BX4410/BX4410A.

Connect your footswitch to the FOOTSWITCH jack, so as to control the sub-harmonics processor and SHAPE filter.

With the sub-harmonics processor switched on (see ) you can add ultra-low bass frequencies to your sound by turning the ULTRABASS control (see chapter 5).

Press the ULTRABASS switch to enable the sub-harmonics processor: The LED above the switch lights up.

Fig. 2.2: BX4410/BX4410A front panel (section 2)

The BASS control in the EQ section allows you to boost or cut the bass frequencies at approx. 50 Hz.

Press the DEEP switch to add low frequencies (ranging from 30 - 200 Hz) to your bass sound. When the DEEP function is switched on, the LED above the switch lights up.

This control governs the upper bass-frequency range at approx. 140 Hz.

The MIDDLE control allows you to boost/cut the low midrange frequencies at approx. 500 Hz.

This control raises/lowers the high midrange frequencies at approx. 1.6 kHz.

The TREBLE control governs the high-frequency range on your BX4410/BX4410A at approx. 7.5 kHz.

Use this switch to enable/disable the BRIGHT effect, which adds some brilliance to the treble frequencies in the range from 2 - 20 kHz. When the BRIGHT function is on, its respective LED lights up.

Fig. 2.3: BX4410/BX4410A front panel (section 3)

When you enable the SHAPE filter with switch , you can use the SHAPE control to modify the filter sound. The filter position is adjustable in the range from 120 Hz - 1.2 kHz.

The SHAPE switch activates the SHAPE filter. When the filter is on, the LED above the switch lights up.

Use the OUTPUT control to determine the overall volume of your BX4410/BX4410A.

2. CONTROL ELEMENTS 5