CONTROLS AND CONNECTIONS
(19) | (20) | (21) | (27) | (28) | (29) |
(22) | (23) | (24) |
| (25) | (26) |
4. MASTER CONTROL SECTION
(19 & 22) AUX 1 AND 2 RETURNS CONTROLS
These are input controls that adjust the levels of the signal at the AUX input jacks.
20) DSP/MIX
This is a master control that adjust the return of the DSP signals that effect all channels.
21) AUX SEND
This is a master control that adjusts the output signal level at the AUX SEND (30) jack.
23) TAPE IN
This adjusts the amount of signal that is sent from the external tape player connected to TAPE IN L,R (34,35) jacks.
24) MONITOR OUT
This adjusts the final level of the MONITOR bus. It affects both the MONITOR output jack and output of the RIGHT/MONITOR SPEAKER OUTPUT (37) jacks when PWR AMP MODE (25) switch is in MAIN/MONITOR position.
25) POWER AMP MODE
The PWR AMP MODE switch allows you to select the signal that will be output from the
26) MAIN MASTER
This adjusts the final level of the MAIN bus signal that is sent to the LEFT/MAIN SPEAKER OUTPUT (37), when PWR AMP MODE (25) switch is in the MAIN/MONITOR position.
27) POWER LED
The red LED will illuminate when the unit is switched on.
28) PHANTOM POWER LED
The LED will illuminate when the PHANTOM POWER (29) switch
is depressed to ON.
29) PHANTOM POWER ON/OFF SWITCH
When this switch is depressed, +48V of phantom power will be supplied to the mic channels.
(Note: When turning on the PHANTOM POWER (29) switch, turn channel level to minimum.)
9