Shure SCM800E manual SCM800 Rear Panel, SCM800 120 VAC Power Connector and Rocker

SCM800 REAR PANEL

120VAC 50/60 Hz 200mA	AUX/INS/INS		INSERT	INSERT	INSERT	INSERT		INSERT	INSERT	INSERT	INSERT
LINK	LINK	(SWITCH)	AUX IN				MIC/PHM/LINE MIC/PHM/LINE MIC/PHM/LINE MIC/PHM/LINE MIC/PHM/LINE
		LINE	MIC/PHM/LINE MIC/PHM/LINE MIC/PHM/LINE
OUT	IN	OUTPUT	SWITCH	SWITCH	SWITCH		SWITCH	SWITCH	SWITCH	SWITCH	SWITCH

+"

8+"

7+"

6

+ " 5

+ " 4 +"

3+"

2+"

1+ "

11 12 13 14 16 17 15 18

MIC"

PHANTOM (PHM) LINE"

LEVEL

(MIC)

LEVEL (LINE)

(SWITCH BEHIND

CONNECTOR)

MODEL SCM800/E REAR PANEL

FIGURE 2

11.SCM800: 120 VAC Power Connector and Rocker

Switch: Switch turns unit on when power cord is plugged into 120 Vac. Can be internally changed to 230 V opera- tion (see Voltage Selection).

SCM800E: 230 VAC Power Connector and Rocker

Switch: Switch turns unit on when power cord is plugged into 230 Vac. Can be internally changed to 120 V opera- tion (see Voltage Selection).

12.DIP Switch: The 7-position DIP switch provides control of the output limiter threshold (see DIP Switches).

13.LINK IN/OUT Jacks: Permit multiple SCM800 mixers to be stacked for additional inputs.

14.LINE OUTPUT Removable Block Connector: Active balanced line-level signal for connection to amplifiers, re- corders or other mixers. If necessary, output level can be changed to microphone level. Refer to the Internal Modifi- cations section of this manual.

15.SEND/RECEIVE 1/4-inch Insert Jacks: Post-fader,post-EQ insert point to add external compressor/limiter, graphic or parametric EQ, or other signal processors. Tip is send, ring is return. Can be modified for use as a Direct Out (see Internal Modifications).

16.AUX/INS/INS 3-Position Slide Switch: Selects either aux input function or insert function for channel 8 (only) In- sert jack. Left switch position is AUX IN; center and right positions are INSERT. This switch is located behind Line Output connector.

17.INPUT 1-8 Removable Block Connectors: Active bal- anced microphone- or line-level inputs.

18.Input 1 - 8 MIC/PHM/LINE 3-Position Slide Switch: Se- lects operation at either microphone-level (left), micro- phone-level with 48 V phantom power (center), or line-lev- el (right) signals. This switch is located behind the remov- able block connector.

4