Setting Attenuation
The attenuation switch on the back of the KSM32 reduces the signal level from the cartridge by 15 dB without altering the frequency response. This can preventextremely high SPL from overloadingthemicrophone.To activate atte- nuation, move the switch to the ª±15 dBº position.
In situations where the high output capability of the KSM32 might overload the microphone preamplifier of a console or mixer, use an attenuation switch (pad) in the mixer or an external inline attenuator such as the Shure A15AS.
LoadImpedance
A load impedance of at least 1000 Ω is recommended. When used with typi- cal modern microphone preamplifiers (rated at about 2500 Ω), the KSM32 pro- vides higher maximum SPL capability and output clipping level. The KSM32 can handle up to 160 dB SPL, and output +15 dBV into a 5500 Ω or greater load with microphone attenuation.
SPECIFICATIONS
Cartridge Type
| |
FrequencyResponse |
|
20 Hz to 20 kHz (see Figure 1) |
|
Directional Pattern |
|
Cardioid (see Figure 2) |
|
Sensitivity (at 1000 Hz) |
|
Open Circuit Voltage | ±36 dBV/Pa (16 mV) typical |
| (1 Pa = 94 dB SPL) |
Self Noise (equivalent SPL)
13 dB typical,
Total Harmonic Distortion (20 Hz to 20 kHz , 2500 Ω load) < 0.08%* for a 120 dB equivalent SPL input
Maximum SPL (20 Hz to 20 kHz, THD < 1%*)
2500 Ω Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 139 dB (154 dB w/ attenuation) 1000 Ω Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 133 dB (148 dB w/ attenuation)
Output Clipping Level (20 Hz to 20 kHz, THD < 1%*)
2500 Ω Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +9 dBV (2.82 V rms) 1000 Ω Load . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . +3 dBV (1.41 V rms)
Dynamic Range (20 Hz to 20 kHz, 2500 Ω load)
126 dB (maximum SPL minus
81 dB (IEC 651)**
Output Impedance
150 Ω (actual)
Attenuation Switch
0 or ±15 dB
English ± 4