Crate Amplifiers GFX-1200H owner manual 11 12 13 14

GFX-1200H Amplifier

11 12 13 14 15

•Slapback delay

•Long delay w/regeneration

•Light Flange

•Heavy Flange

•Slow Chorus

•Fast Chorus

•Chorus w/small room reverb

•Chorus w/large room reverb

•Small room reverb

•Large room reverb

16:INSERT: Connect an external effects device via this jack. Use a stereo 1/4” male Y-cord: ring = send, tip = return, sleeve = ground. See the illustra- tion on the panel to the right for more information.

17:POWER ON LED: Lights when the amplifier is turned on.

18:POWER SWITCH: Turns the amplifier ON in the up position, off in the down position.

19.POWER CORD (rear panel, not shown): Your GFX-1200H is equipped with a heavy-duty ground- ed three-wire power cord. Be sure this cord is prop- erly plugged into a safely wired grounded 120 volt, 60Hz AC power outlet before use. (If your GFX- 1200H was purchased outside the United States, refer to the rear panel for power ratings.) For your safety, never attempt to defeat the ground connec- tion on this cord.

20:SPEAKER JACKS (rear panel, not shown): Use these 1/4” output jacks to connect the amplifi- er to your speaker cabinet(s). Use heavy gauge speaker cables. The GFX-1200H can operate into speaker loads as low as 4 ohms.

21:FUSE (rear panel, not shown): Protects the amplifier against damages caused from a faulty AC power source or other problems. If the fuse blows, replace it ONLY with the same size and type fuse. If the fuse blows repeatedly check the AC source; if it’s okay, contact your Crate dealer for service infor- mation.

16 17 18

22:CHANNEL SELECT / GAIN FOOTSWITCH JACK (rear panel, not shown): Connect the stereo 1/4” plug of the supplied three-button footswitch here for remote control of the Channel Select and Gain Select settings.

23:DSP FOOTSWITCH JACK (rear panel, not shown): Connect the mono 1/4” plug of the sup- plied three-button footswitch here for remote con- trol of the DSP on and off.

Connecting to the Insert jack:

The Insert jack (#16) lets you patch external effects into the amplifier just prior to its power amp stage. Use Crate’s CYC6MS stereo-to-mono Y-cord or an adapter such as Crate’s CA11Y and 2 1/4” mono signal cables to connect to the effect as shown below.

Stereo-to-mono Y-cord:			Y-adapter and 2 cables:
to Insert	TIP		RETURN	TIP	to Insert
jack	RING		SEND	RING	jack
	SLEEVE		GROUND	SLEEVE
(STP201, 3'				(YPP117)
STP202, 6'
STP203, 9')
				T	R I
				I P	N G
T		R I
I P		N G
				(1/4"-TO-1/4"
				MONO SHIELDED
				CABLES)
to	to			to	to
effect	effect			effect	effect
"OUT"	"IN"			"OUT"	"IN"
jack	jack			jack	jack
External Effect				External Effect