The Rear Panel:
28 | 29 | 30 | 31 | 32 |
28.LINE OUT: When using an external effects processor, connect this jack to the input of the effect by means of a shielded signal cable. This jack also doubles as a source for a
29.LINE IN: When using an external effects processor, connect this jack to the output of the effect by means of a shielded signal cable. This jack also doubles as a direct connection to the power amp, bypassing the input and preamp stages. This is useful for “slaving” a pair of ampli- fiers together.
30.SPEAKERS: Use these jacks to connect the amplifier to your speaker cabinet(s) using speaker cables with mono 1/4” plugs. These jacks are wired in parallel. Make sure that the com- bined impedance of your speakers is equal to or greater than 2 ohms! Use the chart below to help determine parallel loads. If in doubt, ask your dealer.
CAB IMP | # CABS TOTAL IMP | CAB IMP | # CABS | TOTAL IMP | |
4 ohms | 2 | 2 ohms | 16 ohms | 2 | 8 ohms |
8 ohms | 2 | 4 ohms | 16 ohms | 4 | 4 ohms |
8 ohms | 4 | 2 ohms | 16 ohms | 8 | 2 ohms |
31.FOOTSWITCH: Use this jack to connect the footswitch cable
32.FUSE: The fuse protects the amplifier from damages caused by a faulty AC power source and/or other problems. If the fuse fails, replace it ONLY with the same size and type. If fuses continue to fail, check the AC source – if the source is okay, contact your Crate dealer for service information.
33.AC LINE CORD (not shown): This grounded power cord is to be plugged into a grounded power outlet, wired to current electrical codes and compatible with the voltage, power, and frequency require- ments stated on the rear panel. Do not attempt to defeat the safety ground connection.
6