Crate Amplifiers manual Using the Footswitch, GTX3500H Rear Panel

Using the Footswitch:

The special Crate four-button footswitch supplied with the GTX3500H performs a variety of functions. The footswitch allows remote channel selection, remote Tap/Save for each channel, and allows access to an additional DSP preset for each channel of the amplifier. Use only the supplied Crate four-button momentary footswitch with the GTX3500H. A standard 5-wire midi cable (supplied) may be used to connect the footswitch to the amplifier.

When the footswitch is connected	GTX3500H REAR PANEL
to the amplifier, the first tap of but-
tons 1 - 3 select the corresponding
channel. Once a channel is selected,
consequent taps of the same button
produce the same results as tapping
the front panel Tap/Save button – you
can use the footswitch to store pre-
sets and set the tempo of an effect.
(See page 8.)

The “original” DSP presets are active for each channel when the #4 footswitch LED is illuminated. These are referred to as “DSP Bank ‘A’.” When the #4 button is switched and the LED is off, a second DSP preset may be stored and recalled for each channel - “DSP Bank ‘B’.”

FOOTSWITCH

NOTE: DSP Bank “B” pre-	1
sets are only accessible

when the footswitch is connected to the amplifier. When the footswitch is not connected, only DSP Bank “A” is accessible.

5-Conductor MIDI cable

2 3 4

SWITCH #1:	SWITCH #2:	SWITCH #3:	SWITCH #4:
CH. 1 SELECT;	CH. 2 SELECT;	CH. 3 SELECT;	LED on: DSP BANK A
TAP/SAVE FOR CH. 1	TAP/SAVE FOR CH. 2	TAP/SAVE FOR CH. 3	LED off: DSP BANK B

9