9:REVERB LEVEL: Use this control to adjust the amount of reverberation: in its full counter clockwise position the signal will be “dry” (without any reverb). As you rotate the control clockwise the amount of reverberation increases.
10:CHORUS: This switch, when depressed, activates the
11:HEADPHONES: Use this jack to listen to the amplifier through a pair of stereo headphones. The internal speaker is disconnected when the headphones jack is used.
CAUTION: To avoid possible damage to your hearing, do not use headphones for extended periods of time at extremely loud listening levels.
12:EXTERNAL SPEAKER: Use this jack to connect the amplifier to an external speaker. The internal speaker is disconnected when this jack is used. The mini- mum impedance for the external speaker is 4 ohms.
13:ON LED: This LED will illuminate when power is applied to the amplifier.
14:POWER: Use this switch to turn the amplifier on and off.
15:AC LINE CORD: (Rear panel, not shown:) This grounded power cord is to be plugged into a grounded power outlet, wired to current electric codes and compatible with voltage, power, and frequency requirements stated on the rear panel. Do not attempt to defeat the safety ground connection.
5