Crate Amplifiers GFX-65T owner manual Channel Tracking

Page 3

GFX-65TGuitar Amplifier with DSP & Channel Tracking

The Digital Signal Processor:

Crate’s Digital Signal Processing offers 16 exciting digital effects, accessible through the DSP Mode control. The effects are described below.

1REV 1 small room reverb

2REV 2 medium room reverb

3REV 3 large room reverb

4REV 4 concert hall reverb

5DLY 1 short slapback + small room reverb

6DLY 2 medium delay + plate reverb

7DLY 3 long delay + large room reverb

8FLNG 1 slow deep flange + reverb

9FLNG 2 flange + reverb + delay

10CHO 1 slow tremolo chorus + reverb

11CHO 2 chorus + reverb + delay

12

RTRY

simulated rotating speaker effect

13

OCTV DN

adds a signal one octave lower than input

14

T-WAH

touch sensitive wah-wah effect

15

I-WAH

inverse wah-wah effect

16

DBLR

simulated second track, slightly out-of-sync

Channel Tracking:

Your Crate GFX-65T gives you the power of Channel Tracking! Once you select a DSP setting for each channel, Channel Tracking recalls those DSP settings automatically – without changing the DSP controls! For example:

Select the Clean channel. Set the DSP Mode to “FLNG 1”(slow flange + reverb)

Select the Overdrive channel, Gain 1. Set the DSP Mode to “CHO 1”(slow chorus + reverb) (the set-

ting for the Clean channel is now saved to memory)

Select the Overdrive channel, Gain 2. Set the DSP Mode to “T-WAH”(touchwah-wah)(the setting

for the Overdrive channel, Gain 1 is now saved to memory)

Reselect the Clean channel (the setting for the Overdrive channel, Gain 2 is now saved to memory)

Now when you go back to the Clean channel, even though the DSP Mode was last set to “T-WAH,” Channel Tracking automatically recalls the last setting for the Clean channel – in this example, “FLNG 1.” Change to the Overdrive channel, Gain 1, and “CHO 1” is recalled. Change to the Overdrive channel, Gain 2, and “T-WAH” is recalled. That’s the power ofChannel Tracking!

(Note: Even when the power is turned off, Channel Tracking still retains the settings – until you change them!)

3

Image 3
Contents Page Table of Contents Channel Tracking Page Connecting to the Insert Jack Page Tuner EMC LVD