VTX350H Three-Channel Guitar Amplifier with Advanced DSP
Using the Footswitch:
The special Crate four button footswitch supplied with the VTX350H performs a vari- ety of functions. The footswitch allows remote channel selection, remote Tap/Save for each channel, and allows access to an additional DSP preset for each channel of the amplifier. Use only the supplied Crate four button footswitch with the VTX350H. A stan- dard
When the footswitch is connected | VTX350H REAR PANEL | |||||
to the amplifier, the first tap of but- |
|
|
|
|
|
|
tons 1 - 3 select the corresponding |
|
|
|
|
|
|
channel. Once a channel is selected, |
|
|
|
|
|
|
consequent taps of the same buttons |
|
|
|
|
|
|
produce the same results as tapping |
|
|
|
|
|
|
the front panel Tap/Save button – |
|
|
|
|
|
|
you can use the footswitch to store |
|
|
|
|
|
|
|
|
|
|
|
| |
presets and set the tempo of an |
|
|
|
|
|
|
|
|
|
|
|
| |
effect. (See page 8.) |
|
|
|
|
|
|
The “original” DSP presets are active for each channel when the #4 footswitch LED is illuminated. These are referred to as “DSP Bank ‘A’.” When the #4 button is switched and the LED is off, a second DSP preset may be stored and recalled for each channel - “DSP Bank ‘B’.”
NOTE: DSP Bank “B” pre- sets are only accessible when the footswitch is connected to the amplifier. When the footswitch is not connected, only DSP Bank “A” is accessible.
FOOTSWITCH
1
2 | 3 | 4 | ||
|
|
|
|
|
SWITCH #1: | SWITCH #2: | SWITCH #3: | SWITCH #4: |
CH. 1 SELECT; | CH. 2 SELECT; | CH. 3 SELECT; | LED on: DSP BANK A |
TAP/SAVE FOR CH. 1 | TAP/SAVE FOR CH. 2 | TAP/SAVE FOR CH. 3 | LED off: DSP BANK B |
9